Cove DW2450 - Page 23


828019 REV B 08/2023
DW2450 and DW2450WS Service Manual
service.subzero.com 800.222.7820
Exterior Component Removal and Installation
REAR INSULATION REMOVAL
To remove the rear insulation, first uninstall the unit.
REMOVE THE REAR INSULATION
Remove the left and right rear insulation pieces.
REAR INSULATION INSTALLATION
INSTALL THE REAR INSULATION
Install the left and right rear insulation pieces.
DRAIN HOSE REMOVAL
WARNING
Turn off the power and water to the product
before starting this procedure.
To remove the drain hose, first uninstall the unit.
REMOVE THE DRAIN HOSE
Use a Phillips screwdriver to loosen the hose clamp
around the drain hose.
Pull the drain hose away from the drain valve.
Use a
1
/
4
" socket to remove the hose guide above
the drain hose.
Remove the drain hose from the unit.
DRAIN HOSE INSTALLATION
INSTALL THE DRAIN HOSE
Route the drain hose through the drain loop support
on the rear of the unit.
Use a
1
/
4
" socket to install the hose guide over the
drain hose.
Place the hose clamp over the end of the drain hose.
Place the drain hose elbow onto the drain valve.
Use a Phillips screwdriver to secure the hose clamp.
1
1
1
2
3
4
1
2
3
4
5
23