COVERPRO 62860 - Roof Side Rail Installation; Assemble and Install Roof Side Rails

3. Assemble a roof side rail using a 3‑Way
Side Connector B (A2), three Rails (4) with
4‑Way Side Connectors (B1) between them,
and then a 3‑Way Side Connector A (A1) on the
other end (see Figure D). Align holes and insert
six M8x45 Round Head Bolts (20) and secure
with Wing Nut for all Side Connectors. The Rails
connect to the straight ends of the Connectors,
and the curved ends of all Connectors must
face up angled the same direction, as shown. If
that is not the case, incorrect connectors were
used, or they were assembled backwards.
A1
A1
A2
4
4
20
B1
B1
4
4
Figure D: Roof Side Rail Assembly
4. Assemble a second identical roof side rail
by repeating the instructions in step #3.
5. Connect the roof side rail assemblies to the ends of
the Rafters (3), align holes and insert eight M8x45
Round Head Bolts (20) and secure with Wing Nut
for all Side Connectors as shown in Figure E.
A1
A2
4
B1
B1
4
4
3
3
3
3
A2
B1
B1
A1
4
20
A2
3
Figure E: Roof Side Rail Installation
6. Make sure all parts assembled up to this
point are firmly joined together.
Page 6 For technical questions, please call 1-888-866-5797. 62860
SAFETY OPERATION MAINTENANCESETUP