COVERPRO 62860 - Foot, Leg, and Stud Assembly; Assemble Feet, Legs, and Studs

Foot, Leg, and Stud Assembly
1. Assemble a Foot (7) to the bottom
of each Center Stud (1):
a. Place a Foot onto the bottom of the Center Stud.
7
1
b. Align the holes and insert one Hex
Head Bolt (12) through them.
12
1
c. Secure with Nut (12).
1
12
7
d. Repeat steps above for remaining
three Center Studs.
2. Attach Corner Leg (6) to the bottom
of each Corner Stud (2):
a. Align holes and insert one M8x45
Round Head Bolt (20) and secure with
Wing Nut as shown in Figure F.
2
6
20
Figure F: Corner Leg Assembly
b. Repeat steps above for remaining Corner Studs.
Page 7For technical questions, please call 1-888-866-5797.62860
SAFETYOPERATIONMAINTENANCE SETUP