NOTE: Photo Burst means Photo Burst your camera
can take a 1 through 10 shot burst every time the
PIR is triggered to take a photo. However, the
camera will only send the FIRST photo.
NOTE: Make sure to press OK to save your settings.
If you do not press OK, your setting will return to
the previous setting.
Trigger Mode Settings:
PIR Sensitivity: The camera is triggered by heat and
motion.
• Low: ≤10˚
• Normal: 10˚- 80˚
• High: ≥80˚
PIR Interval: The camera will be triggered based on
the interval you select. We recommend using a 30
second trigger interval.
• 5-60 seconds in 5 seconds steps
• 1-5 minutes in steps of 1 minute
• 5-60 minutes in steps of 5 minutes
To Next Page
Loading...
