English
10
9
BEFORE USE
3. Reattach the front cover.
Push to reattach the front cover into the two slots on the sides of the purier.
∗
If the front cover is not properly attached, the product will not operate.
▶
How to install lter
Please check before use
The product is for 220V-240V~50Hz/60Hz.
Make sure to connect the power plug to a grounded electric outlet
(220V-240V~50Hz/60Hz) dedicated to the product.
- Be sure to install the lter after removing the plastic packaging.
- Only use it indoors.
- When not in use, remove the power plug from the socket.
- During lter assembly, check the front of the lters.
▶
Filter assembly order :
HEPA lter → deodorization lter → ne dust lter
→ pre-lter
Tips
1. Open the front cover.
Pull both sides of the front cover to open.
2. Take out the lter and remove
the plastic packaging.
Remove the plastic packaging from lters,
excluding the Pre-lter, and assemble them
in the purier in order.
Install the ne dust lter behind the Pre-lter.
∗
Filter assembly order :
HEPA lter →
deodorization lter → ne dust lter
→ pre-lter
∗
When you assemble the ne dust lter, be sure that the blue side of the lter must be at the front.