FILTER REPLACEMENT METHOD
1. Close the feed water supply valve. Drain all the water inside the product’s
water tank.
2. Unscrew the 2 xing screws using a screw driver. Then, open the lter door.
3. Remove the tting on the new lter. Then take out the old lter and replace
with new one.
4. Close the lter door tightly. Screw the 2 xing screws using a screw driver.
Before installing a new lter, please do the lter ushing rst as directed below:
Tips
Filter Name Flushing Time Comment
Neo-sense lter 30 seconds
Plus Inno-
sense
lter
- Flushing is not required.
RO membrane lter 3 minutes Please use Neo-sense ltered water for ushing.
To Next Page
Loading...
