26
25
Maintenance
FILTER REPLACEMENT METHOD
FILTER REPLACEMENT / FILTER REPLACEMENT METHOD
1. Close the water supply valve and completely drain all water from inside the product, and
then pull out the power plug.
2. Remove ttings connecting the lter you wish to exchange, and then exchange the lter
(use the correct tool to remove the ttings).
3. Insert the lower part of the side cover precisely in its place.
▶
▶
Exchange the lter
After exchanging the lter, connect ttings and hoses precisely and
check that there are no leaks. Be sure to rst drain puried water.
Tips
Use new lters only after washing.
- Neo-Sense lter: Install after washing with source water for about 1 minute.
- Membrane (RO) lter: Install the ltered water valve after washing with
source water for about 5 minutes.
- Nanotrap lter: Flush with feed water for 3 minutes. Then install the lter.
- Plus Inno-Sense Filter: Install with no separate ushing.
Tips
To Next Page
Loading...
Need help?
General
