▶
FILTER REPLACEMENT METHOD
3. After separating the tting connected to the lter to replace, please
replace the lter. (Separate the tting using the proper tool.)
4. Please t the groove of the front cover.
After tightening 1 xed screw in the front draining part using the Phillips
driver, let down and close the front draining door.
Use new lters only after washing.
- Plus sediment lter: Install after washing with source water for about 10
seconds.
- Pre-carbon lter: Install in reverse and install after washing with source water
for about 3 minutes.
- RO membrane lter: Install the main water supply valve and install after
washing with source water for about 5 minutes.
- Plus inno-sense lter: Install with no separate ushing.
Tips
When you are replacing lters, please make sure that a corresponding lter
and a hose are rmly connected and that there is no leakage.
It is recommended to empty the water tank lled with the ltered water at
least one time right after the lter replacement.
Tips
To Next Page
Loading...
Need help?
General
