Coway P-300L User Manual

INSTALLATION
1. Close the feed water supply valve. Remove the existing water faucet
with spanner.
2. Connect the adapter to the water pipe with teflon tape.
3. Connect the water faucet with the adapter.
Connect the adapter to a cold tap water pipe.
4. Connect 1/4 inch orange tubing with the connector on the adapter.
Turn the water to flush each filter for at least 5
minutes before connecting the pipe adapter.
5. Connect the power adapter to a grounded outlet.
(P-300R Only)
6. Open the feed water supply valve to run the supply water to the
filtration system.
7. After installation, fill and drain the inner water tank twice.
Make sure to flush the inner water tank before use.
- For this, refer to p. 8 for continuous dispensing.

Coway P-300L Specifications

General

Brand	Coway
Model	P-300L
Category	Water Filtration Systems
Language	English