44
• Until: To keep the hard drive from
filling up, which would prevent you
from recording other shows, you can
set programs to delete when Space
Is Needed (default) or I Viewed any
portion of the program. The Keep Until
I Delete option permanently saves the
recording on your DVR, locking up hard
drive space, until you manually delete
it.
• Start: You can set a recording to begin
On Time (default) or in one-minute
increments between 1 and 5 minutes,
as well as 10 minutes, 15 minutes and
30 minutes before or after the program
begins.
• End: You can also set a recording to
end On Time (default) or in one-minute
increments between 1 and 5 minutes, as
well as 10 minutes, 15 minutes, and 30 minutes before or after the program concludes. Additionally, you can
extend the end time of the recording by 1 hour, 2 hours, and 3 hours after the program concludes.
• Record To: The latest software upgrade from Cox now supports multiple DVRs that may be added to your
Whole Home DVR service. If you rent multiple DVRs for your Whole Home DVR service, then you will see the
Record To option. This option will allow you to select a DVR where the recording will be scheduled. For more
information on this useful service from Cox, see Chapter 9: Whole Home DVR.
You can create different setting combinations for each program that you record through the Guide. Programs recorded
using the RECORD button on the remote control will automatically use the default settings.
4. Press B to confirm recording. A red bar icon will appear at the bottom of the Summary Card to indicate the
recording is set.
As an alternative, you can accept the default settings and skip the above steps by simply pressing B when Record This
Program is highlighted.
Once you have selected a program to record, you can
decidehow long to keep it and whether the recording
shouldstartearly or extend later.
To Next Page
Loading...
