60
Series Manager also lets you modify the recording
priority and determine which programs are recorded
in the event of a conflict.
• Airtimes: You can choose between All Showings or only those that run at a specific time.
• Keep: This setting lets you determine whether to record All Episodes or any number of episodes between
1 and 15.
• Until: To keep the hard drive from filling up, which would prevent you from recording other shows, you can
set programs to delete when Space Is Needed or I Watch any portion of the program. You can also choose
the “I Delete” option to save all shows in the series until you manually delete the series.
• Start: You can set a recording to begin On Time or in one-minute increments between 1 and 5 minutes, as
well as 10 minutes, 15 minutes and 30 minutes before or after the program begins.
• End: You can set a recording to end On Time or in one-minute increments between 1 and 5 minutes, as
well as 10 minutes, 15 minutes, and 30 minutes before or after the program concludes. Additionally, you
can extend the end time of the recording by 1 hour, 2 hours, and 3 hours after the program concludes.
• Resolution: This option becomes available when you select Any Channel in the Channels option. If the
series you wish to record is in HD format, then you would be presented with two choices: HD only, and SD,
if available. Otherwise, you will be presented with choices: SD only, and HD, if available.
3. Press B to accept your changes.
A Note About Record To Option for Series Recordings
Record To option is not available when you edit series recordings because series recordings are expected to be stored
on one DVR. If you still want to change the DVR for a particular series, then we recommend you cancel the series and
reschedule it on a different DVR by using the appropriate DVR in the Record To option.
Change Series Priority
Modify Series Priority allows you to adjust the recording priority of a series and determine which series is recorded
when there is a conflict in the recording schedule.
To do this, begin at the DVR List Menu of a specific DVR.
1. Use the UP or DOWN arrow to highlight
Series Manager.
2. Press B to Modify Series Priority.
3. Use the UP or DOWN arrow to highlight
a series that you would like to put higher
or lower in the priority list. Press SELECT.
A number box will appear in the
highlight bar.
4. Use the UP or DOWN arrow to change the
priority. The number in the box will change.
A lower number means the series has a
higher priority. Press SELECT to confirm
the change.
You can also use the number pad on your remote
control to directly enter a new priority number.
5. Press B to accept all changes. The priority
numbers of all series will be adjusted
accordingly.
To Next Page
Loading...
