9) Test and Adjust Sanitizer level (Chlorine ideal 1 - 3 ppm or Bromine ideal 3 - 5 ppm).
10) The spa temperature is pre-programmed to reach 35°C (95ºF), and will normally do so within
16 to 24 hours. You may raise the water temperature by pressing the TEMP ( ) button on
the control panel, or lower it by pressing TEMP ( ) button. After a few hours, the water
temperature will remain within 1 degree of your selected temperature.
14
14
Venturi Controls
The Venturi Controls allow you to control the intensity of the massage at each jet by adjusting the
mixture of air and water. Simply turn the venturi control lever counter clockwise for a stronger flow
and clockwise for a softer flow.
Diverter Jetting System*
With your Diverter Jetting System, you can control the massaging action of your spa.* On select
models. Using the diverter, the jets are activated in groups, known as jet systems. The jetting systems
are selected by turning the diverter from one side to the other, or select both by leaving the diverter
in the middle. The number of diverters you will have will depend on the model of Coyote Spas™
you have. Feel free to consult your local dealer with any questions regarding the function of this
system, or just jump in and experiment for yourself.
To Next Page
Loading...
