Need help?Do you have a question about the Cozy N Safe EST-361 and is the answer not in the manual?
This child restraint is approved as Universal per Regulation NO.44.04 and fits most car seats.
Ensure vehicle handbook confirms compatibility with Universal child restraints for this age group.
This restraint is classified 'Universal' under stringent conditions, stricter than earlier designs.
If in doubt about usage or fit, consult the child restraint manufacturer or retailer.
Only suitable for vehicles with approved 3-point safety belts (UN/ECE Regulation No.16 or equivalent).
Read instructions carefully. Use harness for specified weight groups. Do not use at home.
Change seat after accidents. Secure seat when unused. Ensure straps are tight and untwisted.
Wear lap straps low. Use only marked load points. Secure luggage. Avoid trapping parts.
Ensure child is securely fastened. No unauthorized alterations. Do not overload; use with cover.
Use only recommended covers. Remove baby before adjustment. Avoid sunlight. Never use second-hand.
Notice: Do not use the child seat in any configuration not shown in the instructions.
Identifies key parts: Headrest, Backrest, Buckle, Harness straps, Base, Adjuster cover.
Identifies Headrest adjuster handle, Belt guide hook, Belt guides, Harness connectors, and Safety belt clip.
Seat is only suitable for vehicles fitted with 3-point safety belts approved to UN/ECE Regulation No.16.
Always ensure shoulder straps are at the correct height, below the harness slot for the child.
Illustrations show the process of removing safety harness shoulder straps from the car seat.
Adjust seat recline to position 4 and release the harness adjuster strap.
Slide harness straps off the connector and pull webbing through the backrest slots.
Slot the two metal sections of the buckle connectors together.
Slot both buckle connectors into the top slot of the buckle until they click into place.
Check harness lock by pulling straps up. Press red button to release harness.
Remove slack by pulling straps up, then pull adjuster strap until harness is fully tightened.
Press adjuster button and pull shoulder straps to loosen the harness.
Place seat against backrest. Thread belt through guides and fasten with 'click'.
Ensure belt through guides, fasten buckle, tighten by pulling diagonal belt upwards.
Place child, check strap height, buckle. Note 4 recline positions available.
Hold adjuster handle, raise/lower headrest to desired height. Ensure it locks securely.
Place seat on vehicle seat, press firmly. Place child into the car seat.
Fasten belt into buckle. Ensure diagonal belt through headrest hook and lap belt through guides.
Tighten belt, check webbing. To disassemble, repeat procedures in reverse order.
Remove crotch pad and buckle, then the headrest cover can be removed for cleaning.
Remove screws from belt guides, slide off backrest cover for cleaning.
Use only recommended covers; unofficial ones compromise safety. Never use without the cover.
The cover is washable at 30°C. Line dry only. Do not bleach, tumble dry, or iron.
Provides contact information for Euro Stock Traders Ltd, Cozy N Safe, including address, tel, fax, and email.
General| Brand | Cozy N Safe |
|---|---|
| Model | EST-361 |
| Category | Car Seat |
| Language | English |
To Next Page