6
Materials Needed
-
Pipe joint compound resistant to propane gases.
-
Caulking compound-silicone rubber with a temperature
rating of 500°F.
-
DO NOT use caulking advertised as paintable or for
bathtub use as most contain fillers and will not withstand
high temperatures.
-
Pipe and fittings to make connections to the furnace.
-
Electrical wiring supplied as needed for optional blower.
-
Minimum wire size is #14 gauge copper.
Tools Needed
- Hand drill or properly grounded electric drill
- 6 ft. folding rule or tape measure
- Screwdrivers (Phillips Head)
- Pliers (wire cutting)
- Stud locator or small finishing nails.
- Tin snips
- 8 and 12 inch adjustable wrenches
- Keyhole or sabre saw
- (2) 10 inch or 12 inch pipe wrenches
- Gloves and safety glasses
Helpful Installation Information
The following booklets will help you in making the installation:
ANSI/NFPA 70, or current edition “National Electrical Code”.
In Canada: CSA C22.1 Canadian Electrical Code.
American National Standard Z223.1 or current edition of the “National
Fuel Gas Code.”
Obtain from the American National Standard Institute, Inc., 1430
Broadway, New York, NY 10018. In Canada, CAN/CGA B149.
Optional Accessories
Vent Extensions: For walls greater than 9 inches thick and up to 24
inches thick, use one of the following Vent Extension Kits:
KIT NUMBER WALL THICKNESS MODELS
9301 9 inches to 15 inches
CDV22 / CDV30 Series
9302 15 inches to 24 inches CDV22 Series
9303 15 inches to 24 inches
CDV14 / CDV30 Series
9304 9 inches to 15 inches CDV14 Series
BLOWER ACCESSORIES 2302 / 2303 – To increase circulation of
warmed air within the heated space, you may use Blower Accessory
Kit 2302, for model series CDV22 / CDV30 or Kit 2303 for model
series CDV14. Both are equipped with a two speed fan and an
automatic fan switch.
THIN WALL COLLAR KIT 9307 – For walls less than 4-1/2 inches
thick, a Thin Wall Collar Kit may be used to increase wall thickness.
VENT-CAP GUARD 9308 – This mounts to the outside of the
exterior wall over the vent cap, to protect pedestrian trac from heat.
VENT SHIELD DEFLECTOR 4318 – Insulated, galvanized sheet
for all direct-vent models.
THERMOSTAT 74592
GAS CONVERSION KITS – Used to convert your furnace from
natural gas to propane gas and from propane gas to natural gas.
See page 12
INTRODUCTION
To Next Page
Loading...
