3. HDD Installation
This series NVR has only one SATA HDD. Please use HDD of 7200rpm or higher.
Please follow the instructions below to install hard disk.
All figures listed here are for reference only.
1. Loosen the screws of the
rear panel and side panel.
2. Fix four screws in the HDD
(Turn just three rounds).
3. Place the HDD in accordance with
the four holes in the bottom.
4. Turn the device upside down and
then turn the screws in firmaly
6. Connect the HDD cable and
power cable.
7. Put the cover in accordance with the
clip and then place the upper cover back.
8. Secure the screws in the rear
panel and the side panel.
To Next Page
Loading...