Need help?Do you have a question about the CPS ELIMINATOR LS3000 and is the answer not in the manual?
General| Brand | CPS |
|---|---|
| Model | ELIMINATOR LS3000 |
| Category | Measuring Instruments |
| Language | English |
Lists the key features and technological advancements of the LS3000 leak detector.
Describes the procedure to power on the LS3000 electronic leak detector.
Explains how to reset the instrument to its highest sensitivity level.
Details how to toggle between the two available audible alarm sounds.
Explains how the single button controls power, reset, and alarm switching.
Outlines the steps and conditions for effectively searching for refrigerant leaks.
Advises on challenges and strategies for leak detection in windy environments.
Explains when it is necessary to reset the LS3000 during a leak search.
Describes how to confirm a suspected leak by repeating the detection process.
Indicates when the battery level is approximately 10% of capacity.
Provides instructions for replacing the Cold Cathode Diode sensor assembly.
Identifies the sensor technology used in the leak detector.
Lists the specific types of refrigerants and gases the detector can sense.
Details the automatic sensitivity selection and maximum detection capability.
Describes the audible and visual methods used to indicate a detected leak.
Specifies the environmental temperature range for optimal operation.
Details the type and quantity of batteries required for the instrument.
Provides information on the continuous operating battery life under different alarm settings.
Lists the physical dimensions of the instrument and its probe.
States the total weight of the leak detector.
To Next Page
