What to do if CPS Measuring Instruments show alternating green/red lights?
If you observe alternating Green/Red lights, it indicates that the SmartAir sensor baseline hasn't been set up. Please refer to the “Set tVOC Sensor Baseline” instructions to resolve this.
Why are my CPS IAQPRO SmartAir showing alternating green/yellow lights?
If you observe alternating Green/Yellow lights, allow 5 to 60 minutes for the tVOC sensor to warm up.
General| Brand | CPS |
|---|---|
| Model | IAQPRO SmartAir |
| Category | Measuring Instruments |
| Language | English |
The SmartAir is not a life-safety device and does not provide absolute values for all indoor airborne hazards.
Paired with CPS Link app for indoor air quality data and customizable reports.
Detects Volatile Organic Compounds and recommends remedial solutions for moderate to severe ranges.
Detects particles ≤ 2.5 µ and 2.5 ≤ 10 µ (microns).
Reads temperature, relative humidity and building pressure. Checks indoor comfort zone per ANSI/ASHRAE Standard 55.
Measures Temperature & Humidity for comfort zones per ANSI/ASHRAE.
Requires approximately 24 hours for baseline setting prior to initial use.
Test procedure includes sensor stabilization and performing a 30-minute test for accurate readings.
Troubleshoots light bar not turning on or displaying incorrect colors.
Solutions for app crashes include checking compatibility and reinstalling the app.
Steps to pair phone/tablet to SmartAir, ensuring Bluetooth is on and app is updated.
Addresses connectivity issues and low/high temperature or humidity readings.
How to confirm if the SmartAir is paired to a mobile device.
Ensuring accurate VOC readings after the unit has been turned off.
To Next Page
