IBR600 Installation Guide
The Cradlepoint IBR600 router will be delivered to site with SIM card installed and router pre-
configured. The router is administered through a cloud-based portal. The installing technician will not
need to make any configuration changes to the CP
1. Connect power supply to electrical outlet and plug connector into CP
2. Connect WiFi and modem antennas (finger tight only). The paddle-shaped antennas for the
cellular modem are marked 4G and go on the side of the Cradlepoint with the SIM card door.
The thinner WiFi antennas go on the side with the LAN ports
3. Connect the power supply to the IBR600 and switch the power on. Test internet connectivity by
connecting a laptop to the LAN port on the router. Use the port on the left, next to the Reset
button)
To Next Page
Need help?
General
