To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 113.201480 and is the answer not in the manual?
General| Model Number | 113.201480 |
|---|---|
| Category | Welding System |
| Input Current | 20A |
| Type | MIG |
| Duty Cycle | 20% at 90A |
| Wire Feed Speed Range | 50-300 ipm |
| Wire Size Compatibility | 0.023-0.030 inches |
Precautions to prevent electric shock hazards.
Guidelines for protecting eyes and body from welding hazards.
Safety measures to prevent fires and explosions.
Electrical power requirements for the welder, including voltage and frequency.
Electrical output characteristics like amperage ranges and arc voltage.
General specifications such as electrode capacity, cable length, and dimensions.
Instructions for unpacking and verifying all welder components against the list.
Steps for initial setup and assembly of the welder before operation.
List of tools required for the assembly process.
Step-by-step guide for securely connecting the electrode holder.
Instructions for properly connecting the work clamp to the cable.
How to safely connect the welder to a 230-volt power source.
How to connect the electrode and work cables to the welder.
Table of common problems, their causes, and suggested remedies.
Advice on maintenance for the fan motor and selector plugs.
Overview of what the welder can do and its capabilities.
Explains the advantages of the Craftsman contact electrode.
Explains the arc welding process and metal fusion.
Techniques for welding in the vertical position, including vertical-down and vertical-up.
Specifications, applications, and properties for E-6011 electrodes.
Specifications, applications, and properties for E-6013 electrodes.
Specifications and properties for hard surfacing electrodes.
Specifications, applications, and properties for E-7014 electrodes.
Specifications and properties for machinable cast iron electrodes.
Specifications and procedures for cutting rods.
Instructions and information needed for ordering replacement parts.
