Craftsman 11A-B2AQ793 User Manual

778-15620© 2018 11A-B2RQ CRAFTSMAN and the CRAFTSMAN logo are trademarks of Stanley Black & Decker, Inc. or an affiliate thereof and are used under license.
Note: Refer to your Operator’s Manual
for instructions on attaching the grass collector.
Wing Nuts
A. Remove the wing nuts and carriage bolts
securing the upper handle to the lower
handle.
Pivot the upper handle
upward.
A. Insert the T-bolts removed in Step 1B
through the handle brackets to secure
the handle in place.
A. Hold blade control handle against upper handle.
B. Slowly pull starter rope handle from engine and
slip starter rope into the rope guide.
C. Tighten rope guide wing knob.
D. Use cable tie to secure cables to lower handle.
A
B
C
D
Starter
Rope Handle
Blade Control Handle
B. Remove T-bolts from
the handle brackets.
T-Bolt
B
A
A
B
B
B. Secure upper handle
to lower handle with
wing nuts (on outside)
and carriage bolts
removed Step 1A.
Pull upward on the
handle until the holes
in lower handle line up
with the holes
in the handle bracket.
A
1
4
2
5
3
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
Fast Start Guide - Engine Start
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
and FOLLOW THE important SAFE OPERATION PRACTICES BEFORE OPERATING.
Need Help?
www.CRAFTSMAN.com or Call 1-888-331-4569

Craftsman 11A-B2AQ793 Specifications

General

Engine	Briggs & Stratton
Engine Displacement	163cc
Starting System	Recoil
Cutting Width	21 inches
Cutting Height Adjustment	Dual-Lever
Mulching Capability	Yes
Side Discharge	Yes
Rear Bag	Yes
Wheel Size (Rear)	11 inches
Engine Type	4-cycle
Deck Material	Steel
Grass Bag Capacity	1.9 bushels
Self Propelled	Yes
Cutting Height	1.25 to 3.75 inches
Wheel Size (Front)	8 inches
Wheel Size	11 in (rear)

Summary

Handle Assembly and Control Setup

Remove Handle Fasteners

Remove wing nuts, carriage bolts, and T-bolts securing the upper handle to the lower handle.

Pivot and Align Upper Handle

Pivot the upper handle upward and pull it to align holes with the handle bracket.

Secure Handle and Connect Controls

Reinsert T-bolts, secure with wing nuts and carriage bolts, and connect starter rope and cables.

Engine Preparation and Starting

Add Engine Oil

Pour the entire contents of the SAE 10W 30 oil bottle into the oil fill and check the level.

Add Fuel

Fill the tank with fresh gas to within 1/2-inch of the top, avoiding E85 or fuel with >10% ethanol.

Set Fuel Valve and Start Engine

Rotate fuel valve to Open, engage blade control, and pull starter rope for engine ignition.