What to do if my Craftsman 137.21602 Saw motor will not run?
If the motor of your Craftsman Saw won't run, there are several potential causes. It could be a defective cord or plug, in which case you should replace the defective parts before using the saw again. It may also be a defective motor. Another possibility is a blown overload breaker, in which case you should restart the saw.
Why is my Craftsman 137.21602 blade breaking?
There are several reasons why the blades on your Craftsman Saw might be breaking: 1. The blade tension might be wrong, so you should adjust it. 2. You might be overworking the blades, so try reducing the feed rate. 3. You might be using the wrong blade, so use a narrow blade. 4. You might be twisting the blade in the wood, so avoid side pressure on the blade.
How to fix Craftsman 137.21602 blade run out?
If your Craftsman Saw blade is running out or not in line with the arm motion, it may be due to unaligned blade holders. To fix this, loosen the blade holder lock screw that holds the blade holder to the arms. Adjust the position of the blade holders, then retighten the blade holder lock screw.
Why is my Craftsman Saw experiencing excessive vibration?
Excessive vibration in your Craftsman Saw can stem from several issues. First, check the saw's mounting; improper mounting can cause vibration, so refer to the mounting instructions for the correct technique. Second, the mounting surface might be unsuitable; a heavier workbench reduces vibration more effectively than a lighter one. Third, ensure the table is not loose or resting against the motor by tightening the table lock knob. Lastly, check for loose motor mountings and tighten the motor mounting screw if necessary.
Essential safety steps before operating the power tool.
Guidelines for safe use, including apparel, eye protection, and securing work.
Ensuring tool integrity and avoiding hazards like dust exposure.
Precautions for operating the scroll saw, including blade tension and table setup.
Tips to prevent injuries, such as proper feeding and blade maintenance.
Instructions for proper grounding to reduce electric shock risk.
Recommendations for selecting and using appropriate extension cords.
Detailed steps for removing and installing pin-end saw blades.
Specific steps for installing pin-end blades, ensuring correct orientation.
Using the variable speed control and ON/OFF switch.
Causes and remedies for blades breaking during operation.
Troubleshooting motor not running or excessive vibration.
General| Type | Table Saw |
|---|---|
| Blade Diameter | 10 inches |
| Power Source | Corded Electric |
| Motor | 15 Amp |
| Arbor Size | 5/8 inch |
| No-Load Speed | 5000 RPM |
| Bevel Capacity | 0-45 degrees |
| Dust Port Size | 2.5 inches |
To Next Page