To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 315.108240 and is the answer not in the manual?
General| Model Number | 315.108240 |
|---|---|
| Type | Circular Saw |
| Blade Diameter | 7-1/4 inch |
| No Load Speed | 5000 RPM |
| Weight | 10 lbs |
| Cord Length | 6 feet |
| Bevel Capacity | 0-45 degrees |
| Blade Size | 7-1/4 inches |
| Depth of Cut at 90 degrees | 2-3/8 inch |
| Depth of Cut at 45 degrees | 1-3/4 inches |
Explains the concept of double insulation in power tools for user safety.
Key safety rules for operating the circular saw, including personal protection and work area.
Details on adjustable depth/bevel, air flow, blade wrench storage, and lock-off switch.
Specifies the intended uses for the circular saw, primarily wood products.
Information on power supply voltage, frequency, and connection type for the saw.
Explanation of the lock-off switch to prevent accidental starting.
Step-by-step guide for safely installing and removing the saw blade.
Guidance on keeping saw blades clean, sharp, and properly set for efficient cutting.
Importance and operation of the lower blade guard for user protection.
Details on what kickback is, its causes, and critical safety warnings.
Tips for reducing the risk of kickback, including blade depth and work support.
Instructions on how to set and adjust the cutting depth of the saw blade.
Proper techniques for initiating a cut to ensure safety and control.
Guidance on proper handling, work support, and cord management for safe operation.
Instructions for aligning cuts using guide notches and the rip guide.
How to adjust the saw for bevel cuts and align the blade with guidelines.
Steps to adjust the bevel angle of the saw blade using the wing nut.
Procedure to verify and adjust the positive 0° bevel stop for accurate 90° cuts.
Instructions for making a pocket cut, emphasizing zero bevel and guard usage.
List of recommended accessories available for the circular saw.
Guidelines for cleaning, avoiding solvents, and servicing the tool.
Information on selecting and using extension cords, including safety checks.
Instructions on where to go for repair parts and service.
Information required when ordering replacement parts for the saw.
