EasyManua.ls Logo

Craftsman 315.11721 - General Information and Safety; Tool Care and Cleaning Tips; Extension Cord Requirements; Recommended Accessories

Craftsman 315.11721
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GENERAL
Only the parts shown on parts list, page eleven, are
Intended to be repaired or replaced by the customer.
All other parts represent an important part of the
double insulation system and should be serviced on-
ly by a qualified service technician.
Avoid using solvents when cleaning plastic parts.
Most piasttcs are susceptible to various types of
commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, carbon dust,
etc. WARNING: DO NOT AT ANY TIME LET BRAKE
FLUIDS, GASOLINE, PENETRATING OILS, ETC.
COME IN CONTACT WITH PLASTIC PARTS. THEY
CONTAIN CHEMICALS THAT CAN DAMAGE
AND/OR DESTROY PLASTIC.
When electric tools are used on fiberglass boats,
sports cars, etc., it has been found that they are sub-
ject to accelerated wear and'_ble premature
failure, as the fiberglass chips a_n_rfndings are
highly abrasive to bearings, brushes, commutator,
etc. Consequently, it is not recommended that this
tool be used for extended work on any fiberglass
material. During any use on fiberglass it is extremely
_mportant that the tool is cleaned frequently by blow-
ing with an air jet. ALWAYS WEAR SAFETY
GLASSES OR EYE SHIELDS BEFORE BEGINNING
POWER TOOL OPERATION.
EXTENSION CORDS Extension Cord Length Wire Size A.W.G.
25-50 Feet 16
The use of any extension cord wilt cause some loss 50-100 Feet 14
of power. To keep the loss to a minimum and to pre-
vent tool overheating, follow the recommended cord WARNING: CHECK EXTENSION CORDS BEFORE
sizes on the chart at right. When tool is used out- EACH USE. IF DAMAGED, REPLACE IMMEDIATELY.
doors, use only extension cords suitable for outdoor NEVER USE TOOL WITH A DAMAG ED EXTENSION
use and so marked. Extension cords are available at CORD, SINCE TOUCHING THE DAMAGED AREA
Sears Catalog Order or Retail Stores. COULD CAUSE ELECTRICAL SHOCK RESULTING
CAUTION IN SERIOUS INJURY.
The operation of any sander can result in foreign ob.
jects being thrown into the eyes, which can result in
Severe eye damage. Always wear safety glasses or
eye shields before commencing power tool opera,
ti0n. We recommend Wide Vision Safety Mask for
use over spectacles, or standard safety glasses...
available at Sears Catalog Order or Retail Stores.
THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENT AND
WERE AVAILABLE AT THE TIME THIS MANUAL WAS PRINTED,
CORD LOCK
Cot, No, 9 2595
CARRYING CASE
Cat, No. 9 1475
ASSORTED SANDING BELTS
Cat. No. 9 22304--X.Fine
Cat. No; 9 22301--Fine
Cat, No. _922302--Medium
Cat. No. _922303--Coarse
Cat. No._9 22305--X-Coarse
DUSTLESS SANDING ATTACHMENT
Car, No, 9 11765
CAUTION: The use of attachments or ecceuortet not listed a_e n_lht be kazerdou=.
Page 6

Related product manuals