To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 358.350160 and is the answer not in the manual?
General| Engine Type | 2-cycle |
|---|---|
| Oil Capacity | 6.8 oz |
| Bar Length | 16 inches |
| Type | Gas-powered |
| Power Output | Unknown |
| Chain Pitch | 3/8 inch |
| Chain Gauge | 0.050 in |
Details the one-year warranty coverage for the Craftsman Gas Chain Saw.
Emphasizes preparation and planning before operating the saw.
Provides crucial safety guidelines for operating the chain saw.
Offers important precautions when handling fuel for the chain saw.
Explains kickback and how to avoid it.
Provides actionable advice to minimize the risk of kickback.
Offers guidance on maintaining control of the saw during operation.
Details safety features built into the saw to reduce kickback.
Explains key controls like ON/STOP, throttle, lockout, choke, and primer.
Advises on checking and adjusting chain tension for proper operation.
Instructions on properly fueling the saw and lubricating the guide bar/chain.
Detailed steps for starting and safely stopping the engine.
Detailed method for felling larger diameter trees using the notch technique.
Explains the specific steps for making the notch cut for felling.
Key considerations and safety points for bucking logs.
Specific techniques for cutting logs, including handling pinch points.
Step-by-step process for limbing a felled tree.
Instructions for safe pruning of branches.
Outlines the user's duties in maintaining the equipment.
Provides general advice and warranty-related maintenance recommendations.
Procedures for checking parts condition, fasteners, chain tension, sharpness, and guide bar.
Guidance on sharpening the chain and maintaining the guide bar.
How to clean the exterior of the unit and its labels.
Procedures for cleaning the air filter to maintain engine performance.
Guidance on inspecting and cleaning the muffler and spark arrestor screen.
Instructions for replacing the spark plug for optimal engine starting and running.
Step-by-step guide for replacing the saw chain.
Instructions on how to adjust the chain tension correctly.
Initial settings for the carburetor adjustment screws.
Step-by-step process for fine-tuning Idle Speed, Low Speed Mixture, and High Speed Mixture.
How to check and ensure smooth acceleration after adjustments.
Procedures for cleaning and protecting the exterior surfaces before storage.
Information regarding the fuel system and storage considerations.
Steps for preparing the engine for storage.
Additional storage tips, including fuel and gasoline can maintenance.
