Craftsman 358.381700-16 in. Bar User Manual (English)

Questions and Answers:

J
johnbartonAug 1, 2025
What to do if my Craftsman Chainsaw engine will not start?
- H
  Hannah SmithAug 1, 2025
  If your Craftsman Chainsaw engine won't start or dies quickly, possible causes and solutions include: * The ON/STOP switch is in the STOP position. Move it to ON. * The fuel tank is empty. Refill with the correct fuel mixture. * The spark plug isn't firing. Install a new spark plug. * Fuel isn't reaching the carburetor. Check for a dirty fuel filter and replace it if needed. Also, inspect the fuel line for kinks or splits; repair or replace the line.
S
Stephanie BrightAug 6, 2025
Why Craftsman 358.381700-16 in. Bar engine will not accelerate?
- S
  stevenlambertAug 7, 2025
  If your Craftsman Chainsaw engine won't accelerate, lacks power, or dies under a load, consider these potential issues: * The air filter may be dirty. Try cleaning or replacing it. * The spark plug could be fouled. Clean or replace the plug and regap it. * The chain brake might be engaged. Disengage the chain brake to resolve the issue.
D
Derrick GallagherAug 12, 2025
Why is my Craftsman 358.381700-16 in. Bar Chainsaw smoking so much?
- E
  Emily SmithAug 13, 2025
  If your Craftsman Chainsaw is smoking excessively, it could be due to several reasons: * The choke might be partially on. Adjust the choke. * The fuel mixture may be incorrect. Empty the fuel tank and refill it with the correct fuel mixture. * The air filter could be dirty. Clean or replace the air filter.
A
Alice HarrisAug 19, 2025
What causes my Craftsman 358.381700-16 in. Bar engine to run hot?
- M
  Melissa BryantSep 12, 2025
  If your Craftsman Chainsaw engine is running hot, consider the following: * The fuel mixture might be incorrect. Consult the “Fueling Engine” section in the Operation section. * The spark plug could be incorrect. Replace it with the correct plug. * Carbon may have built up on the spark arresting screen. Clean the spark arresting screen. * The starter housing might be dirty. Clean the starter housing area.
B
bclarkAug 25, 2025
What to do if Craftsman 358.381700-16 in. Bar Chainsaw oil inadequate for bar and chain?
- J
  Jessica WilsonAug 26, 2025
  If there's inadequate oil for the bar and chain lubrication on your Craftsman Chainsaw: * Check if the oil tank is empty and fill it if needed. * Inspect the guide bar oil hole for blockage and clean it if necessary.