TROUBLE SHOOTING CHART
Engine overheats.
Engine will not stop
running.
Poor trimming
pedormance.
Trimmer vibrates.
Trimmer head does not
retain line
Engine cooling system Clean debris screen and
,clogged, engine cooling fins.
Carburetor out of adjustment. Adjust carburetor. Take the
unit to a Sears Service
Center.
Oil level is low. Add oil.
Defective throttle contm!
lever or wire.
Throttle not adjusted
properly.
Trimmerlinelengthistoo
short.
Enginenot set at FAST
speed.
Set screwfor trimmerhead
is loose,
Inspect and replace
damaged parts.
Movethrottleto thefullOFF
_osition.
Correctline lengthis 21.5
inches. When lessthan 1/2
this length,replacethe line.
Move engine throttle lever to
FAST position.
Tighten set screw with
T-handle wrench,
Trimmer line lengths are Adjust trimmer line to
substanlJally different, approximately equal lengths.
Loose nuts or bolts. Check all bolts and nuts,
including engine bolts.
Replace broken part.
Broken trimmer head.
Trimmer line not propedy
attached.
Follow instructions on decal
or in the Service section of
the owner's manual.
Brokenline retainer. Replacetrimmerhead
assembly,
Trimmerlinenot correctsize, Use Craftsman0.155 inch
diameter trimmerline.
F-(XJO211M 22
To Next Page
Loading...
