EasyManua.ls Logo

Craftsman 580.752011 - User Manual

Craftsman 580.752011
52 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Owner's Manual
®
4.0 HORSEPOWER
:2150 PSi
1.9 GPM
Model No. 580.752011
HOURS: Mort. - Fti. 8 a.m. to 5 p.m. (CT)
ii{!}JCAUTION
Beforeusingthisproduct,readthis
manual and follow all Safety Rules and
Operating instructions.
_.:!IPRECAUCI0N
Antes de utilizar el producto, lea este
manual y siga todas las Reglas de
Seguridad e Instrucciones de Uso.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Visit our Craftsman website: wv_w.craftsman.com
o Safety
o Assembly
o Operation
o Maintenance
o Parts
o Espahol
0 5
Part No. 197191GS Draft 1 (09/20/2005)

Table of Contents

Other manuals for Craftsman 580.752011

Preview: Operator's Manual
Operator's Manual52 pages

Questions and Answers

  • K
    kimwesleyAug 16, 2025
    Why Craftsman Pressure Washer engine will not start?
    • P
      Paul AllenAug 16, 2025
      There are several possible reasons why your Craftsman Pressure Washer engine won't start or runs roughly: * Low oil level: Fill the crankcase to the proper level. * Dirty air cleaner: Clean or replace the air cleaner. * Out of or stale gasoline: Fill the fuel tank with fresh fuel. * Spark plug wire not connected: Connect the wire to the spark plug. * Bad spark plug: Replace the spark plug. * Water in gasoline: Drain the gas tank and fill with fresh fuel. * Overchoking: Open the choke fully and crank the engine.
  • C
    Christopher CarterAug 19, 2025
    What to do if Craftsman 580.752011 Pressure Washer fails to produce pressure?
    • L
      Lydia RobertsAug 19, 2025
      If your Craftsman Pressure Washer isn't producing pressure, try the following: * Replace the spray tip with a high-pressure spray tip. * Clear any blockage in the inlet. * Ensure adequate water flow to the unit. * Straighten the inlet hose and patch any leaks. * Check and clean the inlet hose strainer. * Provide a cooler water supply. * Clear any blockages in the outlet hose. * Clean the spray tip or replace the gun.
  • N
    Nicholas SextonAug 22, 2025
    Why won't my Craftsman 580.752011 engine start, or why does it start and run rough?
    • D
      David PerezAug 22, 2025
      If your Craftsman Pressure Washer engine won't start or runs rough, there are several potential causes: 1. The oil level might be low, so fill the crankcase to the proper level. 2. The air cleaner could be dirty; clean or replace it. 3. The unit may be out of gasoline, so fill the fuel tank. 4. The gasoline may be stale; drain the gas tank and fill it with fresh fuel. 5. The spark plug wire may not be connected; connect it to the spark plug. 6. The spark plug may be bad, so replace it. 7. There may be water in the gasoline, so drain the gas tank and fill it with fresh fuel. 8. The engine may be overchoking; open the choke fully and crank the engine.
  • W
    William RileyAug 25, 2025
    How to troubleshoot Craftsman 580.752011 Pressure Washer failure to produce pressure?
    • D
      Diana PruittAug 26, 2025
      If your Craftsman Pressure Washer fails to produce pressure, consider the following: * A low-pressure spray tip might be installed. Replace it with a high-pressure spray tip. * The water inlet could be blocked. Clear the inlet. * There might be an inadequate water supply. Ensure adequate water flow. * The inlet hose might be kinked or leaking. Straighten the hose or patch the leak. * The inlet hose strainer may be clogged. Check and clean it. * The water supply might be too hot (over 100°F). Provide a cooler water supply. * The high-pressure hose could be blocked or leaking. Clear any blockages in the outlet hose. * The gun might be leaking. Replace the gun. * The spray tip could be obstructed. Clean the spray tip.
  • A
    Amanda HardingAug 28, 2025
    Why Craftsman 580.752011 Pressure Washer detergent fails to mix with spray?
    • C
      Cassandra ZavalaAug 28, 2025
      If the detergent is not mixing with the spray in your Craftsman Pressure Washer: * Ensure the detergent siphoning tube is inserted into the detergent. * Clean or replace the filter/detergent siphoning tube. * Replace the spray tip with a low-pressure spray tip.
  • J
    johnwilliamsAug 31, 2025
    What to do if Craftsman 580.752011 Pressure Washer choke is opened too soon?
    • D
      David PotterAug 31, 2025
      If the choke on your Craftsman Pressure Washer is opened too soon, move it to the halfway position until the engine runs smoothly.
  • E
    Erica ShepherdSep 2, 2025
    What to do if my Craftsman 580.752011 Pressure Washer is out of gasoline?
    • S
      Sonya MillsSep 2, 2025
      If your Craftsman Pressure Washer is out of gasoline, fill the fuel tank.
  • H
    Hannah EnglishSep 6, 2025
    What to do if Craftsman 580.752011 engine runs good at no-load but bogs when load is added?
    • T
      tiffanyjacksonSep 6, 2025
      If your Craftsman Pressure Washer engine runs well without a load but bogs down when a load is added, move the throttle control to the FAST position.
  • J
    jonathan73Sep 9, 2025
    What to do if Craftsman Pressure Washer engine bogs down when load is added?
    • S
      Steven GloverSep 9, 2025
      If the Craftsman Pressure Washer engine runs well without a load but bogs down when a load is added, the engine speed may be too slow. Try moving the throttle control to the FAST position.
  • L
    Lauren HayesSep 12, 2025
    Why detergent fails to mix with spray in my Craftsman Pressure Washer?
    • D
      David SmithSep 12, 2025
      If detergent fails to mix with the spray of your Craftsman Pressure Washer, check these potential causes: 1. Ensure the detergent siphoning tube is fully submerged in the detergent. 2. Inspect the chemical filter for clogs or cracks; clean or replace the filter/detergent siphoning tube if necessary.

Summary

WARRANTY

Limited Warranty Details

Explains terms for defects in material and workmanship for one year.

SAFETY RULES

Hazard Symbols and Meanings

Explains visual safety icons and their implications for injury prevention.

FEATURES AND CONTROLS

Know Your Pressure Washer

Introduction to identifying controls and adjustments on the unit.

Major Components Overview

Describes key parts like pump, engine controls, and connections.

Spray Tips and Usage

Details different spray tip types and their applications.

ASSEMBLY

Unpacking and Parts Check

Steps for removing the unit from its carton and verifying contents.

Adding Engine Oil and Fuel

Procedures for filling the engine crankcase with oil and fuel.

Connecting Hoses and Water Supply

Procedures for attaching the high-pressure hose and water supply.

OPERATION: STARTING AND POSITIONING

Pressure Washer Location and Clearance

Guidelines for positioning the unit safely and ensuring adequate ventilation.

Starting Your Pressure Washer

Step-by-step instructions for starting the engine.

OPERATION: USAGE AND SHUTDOWN

Using Spray Tips and Chemicals

Guide on selecting spray tips and applying cleaning chemicals.

Stopping Your Pressure Washer

Procedures for safely shutting down the engine and relieving pressure.

Rinsing and System Cleaning

Procedures for rinsing the unit and cleaning the detergent system.

SPECIFICATIONS

Engine Technical Information

Details about the engine's design, emissions, and power ratings.

Product Specifications

Lists key performance metrics like PSI, GPM, and shipping weight.

MAINTENANCE

Owners Responsibilities

Outlines tasks for regular maintenance based on usage intervals.

Before Each Use Checklist

Pre-operation checks for safety and readiness of the unit.

Pressure Washer Maintenance Tasks

Specific cleaning and inspection procedures for the washer components.

STORAGE

After Each Use Procedures

Steps for preparing the unit for short-term storage.

Winter Storage Protection

Guidelines to prevent freeze damage during cold weather.

Long Term Storage Preparation

Procedures for storing the unit for extended periods, including fuel system.

TROUBLESHOOTING

Pump Issues

Common problems related to pressure, water volume, and pump operation.

Engine Performance Problems

Solutions for starting, running, and power issues with the engine.

PARTS

Main Unit Exploded View and Parts List

Diagram and list of main components for the pressure washer.

Pump Exploded View and Parts List

Diagram and list of pump components and service kits.

Engine Exploded View and Parts List

Diagram and list of engine components for the 4.0 HP Briggs & Stratton engine.

EMISSION CONTROL SYSTEM WARRANTY

Owners Warranty Responsibilities

Duties of the owner regarding maintenance, claims, and proper use.

Warranted Parts and Coverage

Lists covered components and warranty duration for emissions control systems.

Craftsman 580.752011 Specifications

General IconGeneral
Power SourceGasoline
Flow Rate2.0 GPM
Hose Length25 feet
Weight60 lbs
EngineBriggs & Stratton

Related product manuals