EasyManua.ls Logo

Craftsman 580.752010 - User Manual

Craftsman 580.752010
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
PRESSURE WASHER
4.0 HORSEPOWER
2150 PSI
1.9 GPM
PRESSURE WASHER
CUSTOMER HELPLINE
1-800-222-3136
Model No. 580.752010
HOURS: Mon. - Fri. 8 a.m. to 5 p.m. (CT)
Part No. 195927GS Draft 2 (02/18/2005)
Owner’s Manual
• Safety
• Assembly
• Operation
• Maintenance
• Parts
• Español
PRECAUCIÓN
Antes de utilizar el producto, lea este
manual y siga todas las Reglas de
Seguridad e Instrucciones de Uso.
CAUTION
Before using this product, read this
manual and follow all Safety Rules and
Operating Instructions.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Visit our Craftsman website: www.craftsman.com

Table of Contents

Questions and Answers

  • C
    cervantestimothyJul 31, 2025
    Why won't my Craftsman 580.752010 Pressure Washer engine start or runs rough?
    • M
      Megan CantrellJul 31, 2025
      There are several reasons why your Craftsman Pressure Washer engine might not start or may run roughly: * The oil level may be low, so fill the crankcase to the proper level. * The air cleaner might be dirty; clean or replace it. * The gasoline tank may be empty, so fill the fuel tank. * The gasoline may be stale; drain the gas tank and fill it with fresh fuel. * The spark plug wire may not be connected; connect the wire to the spark plug. * The spark plug may be bad; replace the spark plug. * There may be water in the gasoline; drain the gas tank and fill it with fresh fuel. * The engine may be overchoking; open the choke fully and crank the engine.
  • P
    Peter RodriguezAug 4, 2025
    What to do if Craftsman 580.752010 fails to produce pressure?
    • M
      melissa11Aug 4, 2025
      If your Craftsman Pressure Washer fails to produce pressure, consider these potential causes and solutions: * If a low-pressure spray tip is installed, replace it with a high-pressure spray tip. * If the water inlet is blocked, clear the inlet. * If the water supply is inadequate, provide adequate water flow. * If the inlet hose is kinked or leaking, straighten the inlet hose or patch the leak. * If the inlet hose strainer is clogged, check and clean the inlet hose strainer. * If the water supply is over 100°F, provide a cooler water supply. * If the high-pressure hose is blocked or leaks, clear any blockages in the outlet hose. * If the gun leaks, replace it. * If the spray tip is obstructed, clean the spray tip.
  • J
    Jenny RyanAug 9, 2025
    What to do if Craftsman 580.752010 Pressure Washer engine shuts down during operation?
    • A
      amanda04Aug 9, 2025
      If your Craftsman Pressure Washer engine shuts down during operation, the likely cause is that the fuel tank is empty. Refill the fuel tank.
  • C
    Curtis MartinezAug 13, 2025
    Why does my Craftsman Pressure Washer engine run good at no-load but bogs when load is added?
    • J
      Jonathan OrtegaAug 14, 2025
      If your Craftsman Pressure Washer engine runs well without a load but bogs down when a load is added, the engine speed may be too slow. Move the throttle control to the FAST position.
  • D
    Donna PadillaAug 17, 2025
    What to do if the Craftsman 580.752010 detergent fails to mix with spray?
    • S
      schristensenAug 17, 2025
      If the detergent fails to mix with the spray in your Craftsman Pressure Washer, here are a few things to check: * Ensure the detergent siphoning tube is submerged in the detergent. * Inspect the chemical filter for clogs or cracks; clean or replace the filter/detergent siphoning tube as needed. * If a high-pressure spray tip is installed, replace it with a low-pressure spray tip.
  • R
    Robert WhitakerAug 21, 2025
    What to do if Craftsman 580.752010 Pressure Washer air filter is dirty?
    • L
      Lindsey CrawfordAug 22, 2025
      If the air filter of your Craftsman Pressure Washer is dirty, replace it.
  • R
    Randy MendozaAug 26, 2025
    What to do if choke is opened too soon on Craftsman 580.752010?
    • R
      Rebecca SmithAug 26, 2025
      If the choke is opened too soon on your Craftsman Pressure Washer, move the choke to the halfway position until the engine runs smoothly.

Summary

Warranty

Safety Rules

Hazard Symbols and Meanings

Explains hazard symbols and their meanings for safety.

Features and Controls

Assembly

Remove Pressure Washer From Carton

Instructions for removing the pressure washer from its packaging.

Carton Contents

Lists the items included in the pressure washer carton.

Assembling Your Pressure Washer

Steps to assemble the pressure washer after unpacking.

Add Engine Oil

Guide for adding the correct engine oil to the pressure washer.

Add Fuel

Instructions for adding fuel to the pressure washer's fuel tank.

Connect Hose and Water Supply to Pump

Connects the hoses and water supply to the pressure washer pump.

Checklist Before Starting Engine

Pre-start checks to ensure readiness and safety.

Operation

Pressure Washer Location

Guidelines for safely positioning the pressure washer for operation.

To Start Your Pressure Washer

Step-by-step instructions for starting the pressure washer engine.

How to Stop Your Pressure Washer

Procedures for safely shutting down the pressure washer.

How to Use Spray Tips

Guidance on selecting and using different spray tips for various tasks.

Cleaning and Applying Chemical

Instructions for using detergent with the pressure washer.

Pressure Washer Rinsing

Steps for rinsing surfaces after cleaning with the pressure washer.

Cleaning Detergent Siphoning Tube

How to flush the detergent system after use.

Automatic Cool Down System (Thermal Relief)

Explanation of the system that cools the pump.

Specifications

Engine Technical Information

Details about the engine's technical specifications and certifications.

Product Specifications

Lists the technical specifications of the pressure washer itself.

Maintenance

Owners Responsibilities

Outlines the owner's duties for maintaining the pressure washer.

Maintenance Schedule

A schedule of tasks and intervals for regular maintenance.

General Recommendations

Advice on maintaining performance and extending the pressure washer's life.

Before Each Use

Pre-operation checks to ensure safety and proper function.

Pressure Washer Maintenance

Specific maintenance tasks for the pressure washer unit.

Check and Clean Inlet Screen

Instructions for inspecting and cleaning the water inlet screen.

Check High Pressure Hose

Guidance on inspecting the high-pressure hose for damage.

Check Gun and Nozzle Extension

How to inspect the spray gun and nozzle extension for proper function.

Check In-Line Filter

Steps to service the in-line filter for optimal performance.

Nozzle Maintenance

Procedures for cleaning clogged spray tips.

O-Ring Maintenance

Information on servicing and replacing O-rings.

Pump Maintenance

Procedures for changing the pump oil.

Engine Maintenance

Tasks related to maintaining the pressure washer's engine.

Service Air Cleaner

How to service the engine's air cleaner.

Service Spark Plug

Steps for servicing the spark plug.

Spark Arrester Service

Information on servicing the spark arrester if applicable.

Storage

After Each Use

Procedures for preparing the pressure washer after each use.

Winter Storage

Steps to protect the unit from freezing temperatures.

Long Term Storage

Protect Fuel System

Guidance on protecting the fuel system during long-term storage.

Change Oil

Instructions for changing the engine oil before storage.

Oil Cylinder Bore

How to oil the cylinder bore for storage.

Protect Pump

Using pump saver to protect the pump from freeze damage.

Troubleshooting

Pump has following problems

Common issues with pump pressure, erratic pressure, and low volume.

Detergent fails to mix with spray

Troubleshooting steps when detergent is not mixed with the spray.

Engine runs good at no-load but bogs when load is added

Solutions for engine bogging under load.

Engine will not start; or starts and runs rough

Common causes and corrections for engine starting issues.

Engine shuts down during operation

Reasons why the engine might stop during use.

Engine lacks power

Causes and fixes for reduced engine power.

Engine hunts or falters

Troubleshooting engine hunting or faltering.

Parts

Main Unit - Exploded View and Parts List

Visual breakdown of the main pressure washer unit with part numbers.

Optional Accessories Not Illustrated

List of available optional accessories for the pressure washer.

Engine, 4.0 HP, Briggs and Stratton, 10 D902 - Exploded View

Engine, 4.0 HP, Briggs and Stratton, 10 D902 - Parts List

Emission Control System Warranty

Emission Control System Warranty Statement

Details the warranty for emission control systems and owner responsibilities.

Sears Emission Control Defects Warranty Coverage

Explains the warranty period and coverage for emission-related defects.

Owners Warranty Responsibilities

Outlines the owner's duties regarding maintenance and warranty claims.

Sears Emission Control Defects Warranty Provisions

Specific provisions related to the emission control defects warranty.

Emissions Durability Period and Air Index Information On Your Engine Emissions Label

Craftsman 580.752010 Specifications

General IconGeneral
BrandCraftsman
Model580.752010
CategoryPressure Washer
LanguageEnglish

Related product manuals