EasyManua.ls Logo

Craftsman 580.754902 - User Manual

Craftsman 580.754902
56 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Not for
Reproduction
3100 PSI MAX* @ 2.1 GPM
2400 PSI @ 2.5 GPM MAX*
PRESSURE WASHER
Operator’s Manual
Model No. 580.754902
Part No. 80028107 Rev - (12/07/2017)
• Safety
• Assembly
• Operation
• Maintenance
• Parts
• Español, p. 32
HOURS: Mon. - Fri. 8 a.m. to 5 p.m. (CT)
PRESSURE WASHER
CUSTOMER HELPLINE
1-800-222-3136
ADVERTENCIA
Antes de utilizar el producto, lea este
manual y siga todas las Reglas de
Seguridad e Instrucciones de Uso.
WARNING
Before using this product, read this
manual and follow all Safety Rules
and Operating Instructions.
* This pressure washer is rated in accordance to the Pressure Washer Manufacturers Association
(PWMA) standard PW101-2010 (Testing and Rating Performance of Pressure Washers).


Sears Brands Management Corporation, Homan Estates, IL 60179 U.S.A.
Visit our Craftsman website: www.craftsman.com

Table of Contents

Questions and Answers

  • L
    Laura CollinsAug 11, 2025
    Why is my Craftsman Pressure Washer pump not producing pressure?
    • W
      wyattjosephAug 12, 2025
      The Craftsman Pressure Washer pump may fail to produce pressure for several reasons: * The low-pressure selector nozzle might be installed. Replace it with a high-pressure selector nozzle. * The water inlet could be blocked. Clear the inlet. * There might be an inadequate water supply. Ensure adequate water flow. * The inlet hose could be kinked or leaking. Straighten the hose or patch the leak. * The inlet hose screen might be clogged. Check and clean the screen. * The water supply temperature may be over 100°F. Provide a cooler water supply. * The high-pressure hose or spray gun could be leaking. Replace the faulty component. * The selector nozzle may be obstructed. Clean the selector nozzle. * The pump itself might be faulty. Contact a Sears service facility.
  • J
    Jeffrey GarciaAug 21, 2025
    What to do if my Craftsman Pressure Washer engine will not start?
    • J
      Jennifer TuckerAug 21, 2025
      If your Craftsman Pressure Washer engine won't start, lacks power, runs roughly, or shuts down, consider these potential causes: 1. The engine rocker switch may be in the OFF (0) position. Set it to the ON (I) position. 2. The oil level might be low. Fill the crankcase to the proper level. 3. The air cleaner could be dirty. Clean or replace it. 4. The fuel tank may be empty. Fill it with fuel. 5. The fuel could be stale. Drain the tank and fill it with fresh fuel. 6. The spark plug wire might not be connected. Connect it to the spark plug. 7. The spark plug could be bad. Replace it. 8. There might be water in the fuel. Drain the tank and fill it with fresh fuel. 9. The fuel mixture may be excessively rich. Contact a local service facility.
  • D
    daniellediazAug 31, 2025
    How to fix detergent not mixing with spray in my Craftsman 580.754902 Pressure Washer?
    • E
      Eric DavidsonSep 1, 2025
      If the detergent is not mixing with the spray in your Craftsman Pressure Washer, check the following: * Ensure the detergent siphoning tube is submerged in detergent. * Check if the detergent siphoning tube is clogged or cracked; clean or replace it as needed. * Make sure the soap spray pattern nozzle is selected on the selector nozzle. * Verify that the detergent siphoning check ball is not stuck; free it if necessary.

Craftsman 580.754902 Specifications

General IconGeneral
BrandCraftsman
Model580.754902
CategoryPressure Washer
LanguageEnglish

Related product manuals