IWARNING:Toavoidelectricshock,disconnectthetestleadsfromany
sourceofvoltagebeforeremovingthebatterydoor.
1. Disconnectthetestleadsfromthemeter.
2. Removetheprotectiverubberboot(ifinstalled).---_-_
3. Openthebatterydoorbylooseningthescrewusinga
Phillipsheadscrewdriver.
4. Insertthebatteriesintobatteryholder,observingthe
correctpolarity.
5. Putthebatterydoorbackinplace.Securewiththetwo
screws.
I WARNING: To avoid electric shock, do not operate the meter until the I
battery door is in place and fastened securely.
I
NOTE: If your meter does not work properly, check the fuses and batteries
to make sure that they are still good and that they are properly inserted.
To Next Page
