EasyManua.ls Logo

Craftsman 919.165610 - User Manual

Craftsman 919.165610
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operators Manual
I CRRFTSMRN°I
Permanently Lubricated
2 Stage
Twin Valve
Stationary
AIR COMPRESSOR
Model No.
919.165610
• Safety Guidelines
• Assembly
• Operation
• Maintenance
• Service and Adjustments
• Troubleshooting
• Espahol
CAUTION: Read the Safety Guidelines
and All Instructions Carefully Before
Operating.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Visit our Craftsman website: www.sears.com/craftsman
D21879 Rev. 3 9/17/04

Table of Contents

Questions and Answers

  • W
    williamlewisAug 18, 2025
    Why is my Craftsman 919.165610 Air Compressor not supplying enough air?
    • M
      Mr. Michael DixonAug 18, 2025
      If your Craftsman Air Compressor isn't supplying enough air, it might be due to prolonged excessive air usage. Try decreasing the amount of air you're using. Also, verify that your compressor's SCFM or pressure output meets the accessory's air requirements. If not, you may need a larger compressor. Inspect the hose for holes and replace if necessary. Remove and clean, or replace a restricted check valve. Tighten any loose fittings to prevent air leaks. Finally, clean or replace a restricted air intake filter, but never operate the compressor without the filter.
  • H
    huntermicheleAug 20, 2025
    How to fix air leaks at the fittings of a Craftsman 919.165610?
    • B
      bryantanthonyAug 21, 2025
      If you notice air leaks at the fittings of your Craftsman Air Compressor, the tube fittings might not be tight enough. Tighten the fittings where you hear air escaping, and use a soapy water solution to check for leaks. Be careful not to overtighten.
  • M
    Mark BoyerAug 25, 2025
    What to do if Craftsman 919.165610 Air Compressor has air leaks in the tank?
    • P
      Patricia MahoneyAug 25, 2025
      If your Craftsman Air Compressor has air leaks in the air tank or at the air tank welds, the air tank is defective and must be replaced. Do not attempt to repair the leak, drill into, weld, or modify the air tank, as this will weaken it and could cause it to rupture or explode.
  • R
    Raymond FosterAug 28, 2025
    What causes air leaks at pressure switch release valve on Craftsman 919.165610 Air Compressor?
    • S
      Sophia TaylorAug 28, 2025
      If there are air leaks at the pressure switch release valve of your Craftsman Air Compressor, the pressure switch release valve may be defective. Contact a Trained Service Technician.
  • C
    Cody JimenezAug 30, 2025
    What to do if there are air leaks between head and valve plate in Craftsman Air Compressor?
    • S
      Susan PhillipsAug 30, 2025
      If your Craftsman Air Compressor has air leaks between the head and valve plate, it indicates a leaking seal. Contact a Trained Service Technician.
  • S
    Scott RoblesSep 3, 2025
    How to fix air leaks at check valve in Craftsman Air Compressor?
    • K
      Kelly WhiteSep 3, 2025
      If you have air leaks at or inside the check valve of your Craftsman Air Compressor, it's likely that the check valve seat is damaged. Replace the check valve. Refer to the “To Replace or Clean Check Valve” in the “Service and Adjustment” section.
  • L
    Laura HendersonSep 6, 2025
    What to do if my Craftsman Air Compressor safety valve pops off?
    • J
      Joseph Price DDSSep 6, 2025
      If the safety valve on your Craftsman Air Compressor is popping off due to excessive tank pressure, it could be that the pressure switch isn't shutting off the motor when the compressor reaches its cut-out pressure, or the pressure switch cut-out is set too high. Move the On/Auto/Off lever to the “OFF” position. If the compressor still doesn't shut off, contact a Trained Service Technician.
  • L
    Lisa DelacruzSep 10, 2025
    How to troubleshoot knocking noise in Craftsman 919.165610 Air Compressor?
    • M
      Mary BakerSep 10, 2025
      A knocking noise in your Craftsman Air Compressor can be caused by a defect in the safety valve or a defective check valve. Manually operate the safety valve by pulling on the ring. If the valve continues to leak, it should be replaced. Also, remove and clean, or replace the check valve.
  • T
    teresaperezNov 13, 2025
    What to do if my Craftsman 919.165610 motor will not run?
    • V
      Victoria GibsonNov 13, 2025
      Several factors can prevent your Craftsman Air Compressor motor from running. First, allow the motor to cool down, so the overload switch can automatically reset. The motor should restart automatically once the tank pressure falls below the pressure switch's cut-in point. Also, verify you're using the correct gauge and length of extension cord. Inspect wiring connections inside the pressure switch and terminal box. If paint spray got into the motor, stop operating the compressor in the spray area. Ensure the pressure release valve on the pressure switch unloads head pressure. If not, replace the switch. Finally, check the fuse box for blown fuses (replace if needed), reset the circuit breaker, and ensure you're not using a fuse or circuit breaker with a higher rating than specified. Discon...

Summary

Safety and Hazard Information

Safety Definitions and Instructions

Explains hazard symbols (Danger, Warning, Caution) and general safety rules.

Risk of Explosion and Fire

Details hazards related to flammable materials and ventilation.

Risk of Tank Bursting

Covers conditions that can weaken the air tank, leading to explosion.

Risk from Flying Objects

Risk of Electrical Shock

Risk to Breathing

Risk of Burns and Moving Parts

Installation and Setup

Unit Setup and Location

Wiring and Circuit Protection

Operation and Usage

Compressor Components Overview

Identifies and explains key controls and parts of the air compressor.

Operating Procedures

Covers starting, stopping, break-in, and before-start checks.

Maintenance and Service

Routine Maintenance Schedule

Specific Maintenance Tasks

Service and Adjustments

Storage and Troubleshooting

Troubleshooting Guide

Lists common problems, their causes, and suggested corrections.

Craftsman 919.165610 Specifications

General IconGeneral
Model Number919.165610
Tank Capacity6 Gallons
Max Pressure125 PSI
Air Delivery at 90 PSI2.6 SCFM
Power SourceElectric
Voltage120V
TypePortable
Amperage15 Amps
Horsepower1.5 HP

Related product manuals