EasyManua.ls Logo

Craftsman 919.167370 - User Manual

Craftsman 919.167370
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Owner's Manual
I CRAFTSMFINI
Permanently Lubricated
Tank Mounted
AiR COMPRESSOR
= Safety Guidelines
= Assembly
= Operation
= Maintenance
= Service and Adjustments
= Troubleshooting
= Repair Parts
CAUTION." Read the Safety Guidelines
and All Instructions Carefully Before
Operating.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Visit our Craftsman website: www.sears.com/craftsman
N000317 Rev.o 11J14Jo7

Questions and Answers

  • G
    Glenn MorrisonAug 13, 2025
    What to do if my Craftsman 919.167370 Air Compressor motor will not run?
    • C
      Chris DuranAug 13, 2025
      If the motor of your Craftsman Air Compressor won't run, check the fuse box for a blown fuse and replace it if necessary. Ensure you're using the correct type of fuse (a time delay fuse) and that it matches the specified rating for your circuit. Also, reset the circuit breaker. Avoid using extension cords that are the wrong length or gauge. Disconnect other appliances from the circuit or use a dedicated branch circuit for the compressor. Inspect wiring connections inside the terminal box. If problems persist, have a Trained Service Technician check it.
  • R
    Ryan MercadoAug 17, 2025
    Why is my Craftsman 919.167370 Air Compressor not supplying enough air?
    • K
      Kathryn YuAug 17, 2025
      If your Craftsman Air Compressor isn't supplying enough air, it might be due to excessive air usage or the compressor not being large enough for your air requirements. Try decreasing air usage and check the accessory's air requirements. If the accessory needs more SCFM or pressure than the compressor provides, you'll need a larger compressor. Also, inspect the hose for holes and replace it if needed. Remove and clean the check valve, or replace it if it's restricted. Finally, tighten any loose fittings to prevent air leaks.
  • J
    Joshua ThomasAug 20, 2025
    How to fix air leaks on my Craftsman 919.167370?
    • N
      Nicole WilliamsAug 20, 2025
      To fix air leaks on your Craftsman Air Compressor, start by tightening the fittings where you hear air escaping, but avoid overtightening. Use a soapy water solution to help identify leaks. If the air tank itself is leaking, it must be replaced; do not attempt to repair it due to the risk of bursting. For a leaking safety valve, manually operate it by pulling on the ring. If the valve continues to leak, it should be replaced by a Trained Service Technician.
  • M
    Mark SanchezAug 25, 2025
    What to do if the regulator will not shut off air outlet on my Craftsman Air Compressor?
    • T
      Todd FritzAug 25, 2025
      If the regulator on your Craftsman Air Compressor will not shut off the air outlet, the regulator is damaged and must be replaced.
  • G
    George King PhDAug 28, 2025
    What to do if the pressure drops when using accessories with my Craftsman Air Compressor?
    • B
      Brittney JonesAug 28, 2025
      It's normal for some pressure drop to occur when using an accessory with your Craftsman Air Compressor. However, if the pressure drop is excessive, adjust the regulator following the instructions in the "Description of Operation" paragraph in the Operation Section. Remember to adjust the regulated pressure while the accessory is in use.
  • B
    Beth MitchellSep 1, 2025
    Why does the safety valve pop off on my Craftsman Air Compressor?
    • M
      Michael RobertsSep 1, 2025
      The safety valve on your Craftsman Air Compressor might pop off due to excessive tank pressure. This can happen if the pressure switch doesn't shut off the motor when the compressor reaches its "cut-out" pressure, or if the pressure switch "cut-out" is set too high. Move the On/Auto/Off lever to the "OFF" position. If the unit doesn't shut off, contact a Trained Service Technician.
  • D
    Daniel SparksSep 5, 2025
    Why is my Craftsman 919.167370 making a knocking noise?
    • J
      Joshua JonesSep 5, 2025
      The knocking noise in your Craftsman Air Compressor can be caused by a possible defect in the safety valve. Operate the safety valve manually by pulling on the ring. If the valve still leaks, it should be replaced.
  • K
    Krista DaughertySep 8, 2025
    Why does the regulator knob on my Craftsman 919.167370 leak air continuously?
    • C
      Clayton SharpSep 8, 2025
      If the regulator knob on your Craftsman Air Compressor has a continuous air leak, it means the regulator is damaged and needs to be replaced.

Summary

Warranty Information

Safety Guidelines and Definitions

Hazard: Risk of Explosion or Fire

Hazard: Risk to Breathing (Asphyxiation)

Hazard: Risk of Bursting

Hazard: Risk of Electrical Shock

Hazard: Risk from Flying Objects

Hazard: Risk of Hot Surfaces

Hazard: Risk from Moving Parts

Hazard: Risk of Unsafe Operation

Hazard: Risk from Noise

Installation

Grounding Instructions

Ensure proper grounding to reduce the risk of electric shock.

Voltage and Circuit Protection

Operation

Unit Overview and Controls

Familiarize yourself with compressor components and their functions.

Startup and Shutdown Procedures

Includes break-in, how to stop, and how to start the unit.

Maintenance

To Drain Tank

Service and Adjustments

Check Valve Service

Regulator Replacement

Troubleshooting Guide

Craftsman 919.167370 Specifications

General IconGeneral
Model Number919.167370
Max Pressure150 PSI
Tank Capacity33 Gallons
Power SourceElectric
Horsepower1.6 HP
Voltage120V
Amperage15 Amps
Pump TypeOil-Free
TypePortable Electric Air Compressor

Related product manuals