EasyManua.ls Logo

Craftsman 919.167460 - User Manual

Craftsman 919.167460
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
D24072 Rev. 0 6/18/01
Operators Manual
CAUTION: Read the Safety Guidelines
and All Instructions Carefully Before
Operating.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Visit our Craftsman website: www.sears.com/craftsman
Permanently Lubricated
Single Stage
Side Stack
AIR COMPRESSOR
• Safety Guidelines
• Assembly
• Operation
• Maintenance
• Service and Adjustments
• Troubleshooting
• Español
Model No.
919.167460

Table of Contents

Questions and Answers

  • C
    Christina ColemanAug 20, 2025
    Why is my Craftsman 919.167460 not supplying enough air?
    • M
      Matthew MillerAug 20, 2025
      If your Craftsman Air Compressor isn't supplying enough air, it could be due to several reasons. You might be using air excessively for prolonged periods, or the compressor may not be large enough for your air requirements. Check the accessory's air requirement; if it exceeds the compressor's SCFM or pressure, you'll need a larger compressor. Inspect the hose for holes and replace it if needed. A restricted check valve can also be the cause; remove and clean or replace it. Tighten any loose fittings to address air leaks. Finally, check and clean or replace the air intake filter, but don't operate the compressor without it.
  • R
    robert71Aug 23, 2025
    How to fix a knocking noise in my Craftsman Air Compressor?
    • M
      millerericAug 23, 2025
      A knocking noise in your Craftsman Air Compressor could be due to a defect in the safety valve or a defective check valve. Try manually operating the safety valve by pulling on its ring; if it still leaks, it should be replaced. Also, remove and clean, or replace the check valve.
  • D
    deangriffinAug 26, 2025
    How to fix air leaks at the fittings of my Craftsman Air Compressor?
    • C
      Carlos GrahamAug 26, 2025
      To fix air leaks at the fittings of your Craftsman Air Compressor, start by tightening the fittings where you hear air escaping. You can also check the fittings with a soapy water solution to identify leaks. Be careful not to overtighten the fittings.
  • J
    Jose ReidAug 27, 2025
    What to do if my Craftsman 919.167460 Air Compressor has air leaks in the tank?
    • M
      michaelpriceAug 27, 2025
      If your Craftsman Air Compressor has air leaks in the air tank or at the welds, the air tank must be replaced. Do not attempt to repair the leak, and do not drill into, weld, or otherwise modify the air tank, as this will weaken it and could cause it to rupture or explode.
  • W
    Willie WallaceAug 30, 2025
    What causes air leaks at the check valve of my Craftsman 919.167460 Air Compressor?
    • D
      Diana PhillipsAug 30, 2025
      Air leaks at or inside the check valve of your Craftsman Air Compressor are often caused by a damaged check valve seat. A defective check valve will result in a constant air leak at the pressure release valve when there is pressure in the tank and the compressor is shut off. Replace the check valve.
  • B
    Brandon MurphySep 1, 2025
    What to do if there are air leaks at the pressure switch release valve on my Craftsman Air Compressor?
    • D
      darlenebakerSep 1, 2025
      If there are air leaks at the pressure switch release valve on your Craftsman Air Compressor, it is likely due to a defective pressure switch release valve. Contact a Trained Service Technician.
  • J
    James LarsonSep 4, 2025
    What to do if the safety valve keeps popping off on my Craftsman 919.167460 Air Compressor?
    • L
      Leslie NicholsSep 4, 2025
      If the safety valve on your Craftsman Air Compressor is popping off due to excessive tank pressure, immediately move the On/Auto/Off lever to the 'OFF' position. If the compressor does not shut off, it is recommended to contact a Trained Service Technician.
  • S
    Samantha EvansSep 6, 2025
    Why does the pressure drop on my Craftsman 919.167460 when I use an accessory?
    • D
      Denise FosterSep 7, 2025
      It's normal for some pressure drop to occur on your Craftsman Air Compressor when using an accessory. However, if the pressure drop is excessive, adjust the regulator following the instructions in the 'Description of Operation' paragraph in the 'Operation Section'. Remember to adjust the regulated pressure under flow conditions (while the accessory is being used).
  • A
    Ashley MurraySep 9, 2025
    What causes air leaks between the head and valve plate of my Craftsman 919.167460 Air Compressor?
    • B
      Brent ReedSep 9, 2025
      Air leaks between the head and valve plate of your Craftsman Air Compressor are caused by a leaking seal. Contact a Trained Service Technician.
  • T
    Timothy DavisSep 12, 2025
    Why does my Craftsman 919.167460 Air Compressor regulator knob have a continuous air leak?
    • M
      Mary HamptonSep 12, 2025
      A continuous air leak from the regulator knob of your Craftsman Air Compressor indicates a damaged regulator. Have it checked by a Trained Service Technician.

Craftsman 919.167460 Specifications

General IconGeneral
Model Number919.167460
Maximum Pressure150 PSI
Voltage120 V
Amperage15 amps
Pump TypeOil-free
Horsepower1.5 HP
TypePortable

Related product manuals