What to do if my Craftsman 921.152150 motor will not start?
First, ensure the power cord is properly plugged in and the switch is turned on. Check your circuit box for the correct size fuse. If the fuse has tripped, reset it and attempt to restart the unit. If the fuse repeatedly trips, consider replacing the check valve or contacting a service technician.
What to do if my Craftsman 921.152150 Air Compressor has excessive tank pressure?
Move the Auto-On/Off lever to the Off position. If the unit doesn’t shut off, unplug it from the power source and contact a service technician.
How to fix air leaks between the head and cylinder of my Craftsman 921.152150 Air Compressor?
Ensure that the head bolts have the proper torque. If the leak persists, it is recommended to contact a service technician.
What to do if my Craftsman 921.152150 leaks air from the tank body or tank welds?
Never drill into, weld, or modify the air tank, as this will weaken it and could cause it to rupture or explode. The compressor cannot be repaired, so discontinue using it.
What to do if there's excessive moisture in the discharge air from my Craftsman 921.152150 Air Compressor?
If you notice excessive moisture in the discharge air, drain the tank after each use to remove water. Remember that high humidity environments can cause excessive condensation. Consider using water filters on your air line. Also, ensure the compressor’s air output is greater than your tool’s air consumption rate. Note that water condensation is not caused by compressor malfunction.
Why is my Craftsman 921.152150 Air Compressor leaking air from the safety valve?
Try operating the safety valve manually by pulling on the ring. If the valve continues to leak when in the closed position, it should be replaced.
What to do if regulated pressure gauge drops when using an accessory with my Craftsman 921.152150 Air Compressor?
If there is an excessive pressure drop when using an accessory, replace the regulator. Remember to adjust the regulated pressure under flow conditions (while the accessory is being used). It is normal for the gauge to show minimal pressure loss during initial use of the tool.
How to resolve air leaks at the check valve of my Craftsman 921.152150 Air Compressor?
If you have a defective check valve resulting in a constant air leak at the pressure relief valve when there is pressure in the tank and the compressor is shut off, drain the tank. Then, remove and either clean or replace the check valve.
Read and understand all safety rules and operating instructions before using this equipment.
Essential safety steps to ensure proper grounding and prevent electric shock.
Detailed steps for preparing and starting the compressor for daily operation.
Schedule for checking safety valve, unit, tank, and power cord before each use or daily.
General| Model Number | 921.152150 |
|---|---|
| Power Source | Electric |
| Tank Size | 6 Gallons |
| Max PSI | 150 PSI |
| CFM at 90 PSI | 2.6 CFM |
| Voltage | 120V |
| Amperage | 12 Amps |
| Pump Type | Oil-Free |
| Type | Portable |
| Horsepower | 1.5 HP |
To Next Page