Why my Craftsman 944.361063 Trimmer does not start?
Your Craftsman Trimmer might not be starting due to several reasons: a dirty air filter (clean or replace it), lack of fuel (fill the fuel tank), stale or water-contaminated fuel (drain and refill with fresh gasoline), a disconnected spark plug wire (connect it), a bad spark plug (replace it), or the throttle control lever is not in the correct position (move it to the FAST position).
What to do if my Craftsman 944.361063 has loss of power?
If your Craftsman Trimmer is experiencing a loss of power, consider these potential causes: a dirty air filter (clean or replace it), a buildup of grass and debris under the trimmer (clean the underside of the trimmer and head), too much oil in the engine (check the oil level), or walking speed too fast (trim at a slower pace).
How to improve poor trimming performance of Craftsman 944.361063 Trimmer?
Poor trimming performance in your Craftsman Trimmer can be caused by: trimmer line length being too short (replace the line if it's worn or broken to half its original length), or the throttle control lever not being in the correct position (move the throttle lever to the FAST position).
What to do if Craftsman Trimmer head does not retain line?
If your Craftsman Trimmer head isn't retaining the line, it could be due to: the trimmer line not being properly installed (follow the instructions in the Maintenance section), a broken line retainer clip (replace the string carrier plate assembly), or using the incorrect size of trimmer line (use .155 diameter trimmer line).
How to fix excessive vibration in Craftsman Trimmer?
Excessive vibration in your Craftsman Trimmer can be caused by: uneven or broken lines (check trimmer lines), loose nuts or bolts (check all hardware, including engine bolts), or a damaged trimmer head (check or repair the trimmer head).
What causes loss of head drive in Craftsman 944.361063 Trimmer?
A loss of head drive in your Craftsman Trimmer can be caused by the belt not driving. To resolve this, put the belt on the pulleys, or replace the belt if it is broken.
Why is my Craftsman 944.361063 hard to push?
If your Craftsman Trimmer is hard to push, it might be because the handle height position isn't right for you. Adjust the handle height to suit your preference.
Covers safe practices during operation, handling, and use of the trimmer.
Details procedures for engine operation and effective trimming techniques.
Details routine checks, general advice, and pre-use tasks for upkeep.
Procedures for servicing engine oil, air filter, and general unit cleaning.
Steps for cleaning, fluid preparation, and securing the unit for storage.
To Next Page
General