Craftsman C950-52060-1

Questions and Answers

N
Nicole LopezAug 1, 2025
What to do if my Craftsman C950-52060-1 Snow Blower engine does not start?
- Q
  qjohnsonAug 1, 2025
  If the Craftsman Snow Blower engine doesn't start, ensure the key is in the ON position. Also, try pressing the primer button twice. If the engine is frozen, put the snowthrower in a heated garage to unfreeze it. Check if the fuel tank is empty and fill it if needed. For a cold engine, turn the choke to the closed position, then press the primer and start the engine. Alternatively, turn the choke to the open position and crank the engine repeatedly. Ensure the spark plug wire is connected, or replace the spark plug if there's no spark. If there's water or old fuel in the tank, drain it and refill with fresh fuel. For electric start models, ensure the cord is plugged in or replace the defective cord, and reset the circuit breaker if it has tripped.
R
Rebecca EdwardsAug 5, 2025
Why does my Craftsman Snow Blower engine start hard or run poorly?
- J
  jose33Aug 6, 2025
  If the Craftsman Snow Blower engine starts hard or runs poorly, try moving the choke to the OPEN position if the fuel mixture is too rich. If the spark plug is faulty, fouled, or gapped incorrectly, clean and re-gap it, or consult an authorized dealer. Also, ensure the fuel cap vent is clear.
K
Kathy RodriguezAug 10, 2025
What to do if the discharge chute on my Craftsman C950-52060-1 is clogged with snow?
- S
  stephanie50Aug 10, 2025
  If the Craftsman Snow Blower discharge chute is clogged with snow, stop the engine immediately. Always use a clean-out tool, not your hands, to clear the clog. Clean the discharge chute and the inside of the auger housing. Refer to “Warnings” in the Operator Safety section for additional safety information.
B
Betty VelasquezAug 16, 2025
How to fix a loose or damaged auger drive belt on a Craftsman C950-52060-1 Snow Blower?
- A
  Angel EdwardsAug 16, 2025
  To address a loose or damaged auger drive belt on your Craftsman Snow Blower, adjust the auger control cable. Refer to “Cable Adjustment” in the Maintenance section of this manual. Alternatively, see an authorized dealer for belt replacement.
J
John OrtegaAug 20, 2025
How to fix a Craftsman C950-52060-1 when the auger does not stop within 5 seconds?
- C
  Chelsea PenningtonAug 20, 2025
  If the auger on your Craftsman Snow Blower does not stop within 5 seconds, adjust the auger control cable. Refer to “Cable Adjustment” in the Maintenance section of this manual. If the auger still does not stop within 5 seconds, consult an authorized dealer for repair.
J
Jake McdonaldAug 26, 2025
What to do if there is a foreign object lodged in the Craftsman C950-52060-1 Snow Blower auger?
- J
  Jeanette KrauseAug 26, 2025
  If a foreign object is lodged in the auger of your Craftsman Snow Blower, stop the engine immediately. Always use the clean-out tool to clear a clogged chute, and never use your hands. Remove the object from the auger. Refer to the “Warnings” in the Operator Safety section for safety guidelines.