EasyManua.ls Logo

Craftsman CM4.33 - Page 38

Craftsman CM4.33
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Title part xxx
Subtitle part xxx
38
craftsman marine diesel engines CM4.33 / cm4.42
Problem Probable cause Solution
6.
Engine becomes
overheated
• Level of cooling liquid too low
• Raw water seacock closed
Raw water strainer clogged
Leakage in raw water entry system
Defective thermostat
Cooling liquid pump defective
Defective impeller of raw water pump
Defective injector / injector pump
Oil level too high
Oil level too low
Defective oil lter
Check/top up
Check and open
Check / clean
Check/ replace
Check / replace
Check / replace
Check / replace
Check and clean or replace if necessary
Lower oil level
Top up / Replace
7.
Not all cylinders are perfor-
ming well
Air in the fuel system
Fuel lter clogged up by water and/or dirt
Leakage in fuel supply line or fuel injection line
Defective injector / injection pump
Fuel line clogged
Defective glow plugs
Incorrect valve tolerance
Filter of electrical fuel lift pump clogged
Defective electrical fuel lift pump
In all these cases, please consult your authori-
zed dealer and ask him to solve the problem
8.
Engine has little or no oil
pressure
Oil level too low
Clogged oil lter
Defective oil pump
Excessive inclination angle of engine
Incorrect SAE-specication or quality of lubrication oil
Oil pressure apparently too low on account of defective oil pressure
switch,sensor or gauge
To up till corect oil level
Replace
Repair / replace
Check / adjust alignment
Replace by good quality engine lubricating oil
Replace defective component
9.
Engine oil cumsumption
excessively
Oil level too high
Excessive inclination angle of engine
Incorrect SAE-specication or quality of lubrication oil
Leakage in lubrication oil system
Excessive wear and tear to cylinder or piston
Insufcient supply of combustion air
Overload of engine
Lower the oil level
Check / adjust alignment
Replace by good quality lubricating oil
Repair / replace
Check compression; overhaul engine, if needed
Check air inlet and ventilation openings in
engine room
Check the dimensions of the boat propeller
14 Problems and solutions

Related product manuals