What to do if Craftsman CMXCESM258 Battery Charger will not turn on?
If your Craftsman Battery Charger won't turn on, check the AC outlet for an open fuse or circuit breaker. Also, inspect the power cord and any extension cords for loose connections. It's also recommended to have the battery checked for defects.
What to do if Craftsman CMXCESM258 is unable to keep battery fully charged?
If your Craftsman Battery Charger can't keep the battery fully charged in maintain mode, first ensure there are no active loads draining the battery. If loads are present, remove them. If there are no loads, the battery may be defective and should be checked or replaced.
What to do if Bad Battery LED is lit on Craftsman CMXCESM258 Battery Charger?
If the Bad Battery LED is lit on your Craftsman Battery Charger, the battery may be defective. Ensure there are no loads on the battery; if present, remove them. The battery may be overheated, so allow it to cool. The battery may be too large, have a short circuit, too low capacity, too old, or not hold a charge. In any case, have the battery checked or replaced.
What to do if Craftsman CMXCESM258 is unable to reach the “full charge” voltage?
If the battery is unable to reach the full charge voltage while using the Craftsman Battery Charger, this may be because you are trying to charge a large battery, or a bank of batteries, on too low of a current setting. Try again with a higher current setting or have the battery checked or replaced.
Why Craftsman CMXCESM258 Battery Charger charging LED never lit?
If the charging LED on your Craftsman Battery Charger never lights up, it could be because the battery voltage is low. Press the START/STOP button to start charging.
What to do if Craftsman Battery Charger connections to the battery are reversed?
If the connections to the battery are reversed on your Craftsman Battery Charger, the battery is connected backwards. Unplug the charger and reverse the connections to the battery.
What to do if Craftsman CMXCESM258 cannot desulfate the battery?
The battery could not be desulfated; have it checked or replaced.
What to do if Craftsman Battery Charger battery voltage is still under 10V?
If, after 2 hours of charging with the Craftsman Battery Charger, the battery voltage is still under 10V (for a 12V battery) or 5V (for a 6V battery), the battery could be bad. Have it checked or replaced.
Covers instructions, child safety, environmental exposure, accessory use, and cord care.
Warns about explosive gases from batteries and the importance of following instructions.
Have assistance, keep first aid supplies, wear protective gear, and avoid touching eyes.
No smoking, no flames, avoid metal tool drops, remove jewelry.
Steps and warnings before starting the charging process.
Recommendations for safe and optimal charger placement.
Essential steps for connecting the charger clips to the battery terminals.
Detailed steps for charging a battery installed in a vehicle.
Detailed steps for charging a battery removed from a vehicle.
Description of buttons, LEDs, and digital display functions.
Step-by-step guide for charging batteries in and out of a vehicle.
Guidelines for AC power connection, grounding, and extension cords.
Procedures for keeping the charger in good working condition.
Lists common problems, causes, solutions, and error codes.
Technical details including input/output voltage and current ratings.
Details of the two-year limited warranty.
General| Product Type | Battery Charger |
|---|---|
| Voltage | 12V |
| Amperage | 2A |
| Input Voltage | 120V AC |
| Output Voltage | 12V DC |
| Charging Current | 2A |
| Weight | 1.5 lbs |
| Battery Type | Lead Acid |
| Features | reverse polarity protection |
| Charging Modes | Maintenance |
| Safety Features | Overcharge Protection, Short Circuit Protection |
To Next Page