Craftsman CMXGLXT2700

Questions and Answers

J
Jeffrey DominguezAug 7, 2025
Why Craftsman Media Converter engine will not start?
- K
  Kathy KingAug 8, 2025
  Your Craftsman Media Converter engine might fail to start due to several reasons: * The engine switch is in the “OFF” position. To resolve this, move the switch to the “ON” position. * The fuel shut-off valve is in the “OFF” position. Correct this by moving the valve to the “ON” position. * There is no fuel. Simply add fuel. * The spark plug is faulty. Replace the spark plug. * The spark plug is disconnected. Connect the spark plug. * The unit is loaded during start up. Move valve handle back and forth, remove load.
D
duanesmithAug 16, 2025
What to do if Craftsman CMXGLXT2700 engine shuts off during operation?
- M
  Monica HansenAug 16, 2025
  If your Craftsman Media Converter's engine shuts off during operation, it could be due to: * Being out of fuel: Fill the fuel tank. * Low oil level: Fill the crankcase to the proper oil level.
M
Matthew HughesAug 23, 2025
Why is the Craftsman Media Converter wedge movement slow or erratic?
- N
  Nicole ThompsonAug 23, 2025
  Slow or erratic wedge movement in your Craftsman Media Converter can be attributed to: * Air in the hydraulic oil system: Purge air by extending and retracting the wedge several times until the motion is smooth. * Debris lodged in beam guides: Clear debris from the beam. * Low hydraulic oil: Check the oil level and add as needed.
T
terry63Aug 30, 2025
How to fix excessive bouncing while towing Craftsman Media Converter?
- R
  Robert MorrisonAug 30, 2025
  Excessive bouncing while towing your Craftsman Media Converter can be caused by: * Under-inflated tires: Inflate the tires to the proper pressure level. * Over-inflated tires: Inflate the tires to the proper pressure level.