Craftsman CMXGLXT3200

Questions and Answers

M
Michael FosterAug 12, 2025
Why Craftsman CMXGLXT3200 engine will not start?
- A
  Andrew WigginsAug 12, 2025
  Your Craftsman Media Converter engine might fail to start due to several reasons: * The engine switch is in the “OFF” position. To resolve this, move the switch to the “ON” position. * The fuel shut-off valve is in the “OFF” position. Correct this by moving the valve to the “ON” position. * There is no fuel. Simply add fuel. * The spark plug is faulty. Replace the spark plug. * The spark plug is disconnected. Connect the spark plug. * The unit is loaded during start up. Move valve handle back and forth, remove load.
D
David Ali PhDAug 18, 2025
What to do if Craftsman CMXGLXT3200 Media Converter engine shuts off during operation?
- B
  Billy JacksonAug 18, 2025
  If your Craftsman Media Converter's engine shuts off during operation, it could be due to: * Being out of fuel: Fill the fuel tank. * Low oil level: Fill the crankcase to the proper oil level.
P
Patricia JohnsonAug 27, 2025
Why is the Craftsman CMXGLXT3200 Media Converter wedge movement slow or erratic?
- M
  Meghan MeyerAug 27, 2025
  Slow or erratic wedge movement in your Craftsman Media Converter can be attributed to: * Air in the hydraulic oil system: Purge air by extending and retracting the wedge several times until the motion is smooth. * Debris lodged in beam guides: Clear debris from the beam. * Low hydraulic oil: Check the oil level and add as needed.
L
Lori HarrisSep 3, 2025
How to fix excessive bouncing while towing Craftsman CMXGLXT3200 Media Converter?
- S
  stephen52Sep 3, 2025
  Excessive bouncing while towing your Craftsman Media Converter can be caused by: * Under-inflated tires: Inflate the tires to the proper pressure level. * Over-inflated tires: Inflate the tires to the proper pressure level.