Craftsman CMXGVAM1144043 Fast Start Guide

778-15657
© 2018 34M CRAFTSMAN and the CRAFTSMAN logo are trademarks of Stanley Black & Decker, Inc. or an affiliate thereof and are used under license.
Using four clevis pins and four cotter pins
from the manual bag, install the labeled
tines onto the tine shaft inner tines first, then
the outer tines and exactly as shown.
A1
A2
B1
B2
B2 B1
A2
A1
Remove the remaining clevis pin and cotter
pin from the manual bag, install the wheel
assembly into the chain case bracket
Remove the two screws
from the bracket in the
chain case. Insert the
horizontal bracket into the
chain case brackets and
secure the depth stake
assembly in place with the
screws just removed
Remove the bolts, washers and nuts from
the chain case bracket. Place the handle into
position and secure with the previously removed
hardware.
Remove the handle
adjustment crank from
the handle. Rotate the
handle upward and
secure it in place with
the handle
adjustment
crank.
When the handle is in place, insert the
clutch cable into the cable guide on the
handle
Tools Required:
• 1/2-inch wrench (or adjustable wrench)
Handle
Tines
Depth Stake
HandleAdjustment Crank
Clutch Lever
1
4
2
5
3
6
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING.
Need Help?
www.CRAFTSMAN.com or Call 1-888-331-4569
Fast Start Guide - Assembly

Craftsman CMXGVAM1144043 Specifications

General

Brand	Craftsman
Model	CMXGVAM1144043
Category	Tiller
Language	English