Craftsman Sears 944.602892 User Manual (English)

Questions and Answers:

M
masonjamesJul 30, 2025
How to fix uneven cut from Craftsman Sears 944.602892?
- H
  herrerakristiJul 30, 2025
  An uneven cut with your Craftsman Lawn Mower can be caused by: * A worn, bent, or loose blade. Replace the blade and tighten the blade bolt. * The mower deck not being level. Level the mower deck. * A buildup of grass, leaves, and trash under the mower. Clean the underside of the mower housing. * A bent blade mandrel. Replace the blade mandrel. * Clogged mower deck vent holes from a buildup of grass, leaves, and trash around the mandrels. Clean around the mandrels to open the vent holes.
B
brett94Aug 3, 2025
Why Craftsman Lawn Mower battery will not charge?
- A
  Alyssa OwensAug 3, 2025
  If the battery on your Craftsman Lawn Mower is not charging, it could be due to: * Bad battery cells. Replace the battery. * Poor cable connections. Check and clean all connections. * A faulty regulator (if equipped). Replace the regulator. * A faulty alternator. Replace the alternator.
T
Tiffany GonzalezAug 11, 2025
What to do if Craftsman Sears 944.602892 blades will not rotate?
- D
  Dr. Erin LynnAug 12, 2025
  If the blades on your Craftsman Lawn Mower won't rotate, it could be due to several reasons: * There might be an obstruction in the clutch mechanism. Remove the obstruction. * The mower drive belt could be worn or damaged. Replace the mower drive belt. * The idler pulley may be frozen. Replace the idler pulley. * The blade mandrel might be frozen. Replace the blade mandrel.
T
Tanner NunezAug 16, 2025
What causes loss of drive in Craftsman Lawn Mower?
- A
  Antonio MillerAug 16, 2025
  Loss of drive in your Craftsman Lawn Mower can occur if: * The freewheel control is in the “disengaged” position. Place the freewheel control in the “engaged” position. * The motion drive belt is worn, damaged, or broken. Replace the motion drive belt. * Air is trapped in the transmission during shipment or servicing. Purge the transmission.
J
Justin PrattAug 20, 2025
What to do if Craftsman Sears 944.602892 headlights are not working?
- B
  brandon61Aug 20, 2025
  If the headlights on your Craftsman Lawn Mower are not working, check the following: * Ensure the switch is “ON”. If it's “OFF”, turn it “ON”. * The bulbs or lamps may be burned out. Replace them. * There might be a faulty light switch. Check or replace the light switch. * Look for loose or damaged wiring. Check the wiring and connections. * A blown fuse. Replace the fuse.
D
damon47Aug 25, 2025
Why does Craftsman Lawn Mower engine keeps running after leaving the seat?
- S
  Steven NicholsonAug 25, 2025
  The engine of your Craftsman Lawn Mower might continue to run when you leave the seat with the attachment clutch engaged due to a faulty operator-safety presence control system. Check the wiring, switches, and connections. If the issue persists, contact an authorized service center or department.

Craftsman Sears 944.602892 Specifications

General

Model Number	944.602892
Category	Lawn Mower
Power Source	Gasoline
Engine Type	4-Cycle
Engine Displacement	140cc
Drive System	Self-Propelled
Mulching Capability	Yes
Bagging Capability	Yes
Side Discharge Capability	Yes
Cutting Width	21 inches
Wheel Size	8 inches