Craftsman Smart Lawn Connect Kit User Manual

*
Smart Lawn Connect Kit
Installation Instructions
Installation Guide:
1 Using screwdriver, remove (2) two-piece plastic retainer plugs on rearward end of Control Panel
(see illustration below).
A. Insert screwdriver into recess in retainer ring,
underneath plunger, and gently pry upward.
B. Insert screwdriver between metal console and
retainer ring and gently pry upward to remove.
These instructions apply to Craftsman Pro Series Zero Turn riding mowers (model #247.XXXXX)
Please read through entire instruction sequence before beginning installation.
Congratulations on purchasing a Craftsman Smart Lawn Connect Kit. The Craftsman Smart Lawn Connect Plug
will easily plug in to the back side of your Craftsman Rider’s Ignition Switch located on the dashboard.
October 26, 2016
Control Panel
WARNING Before performing any maintenance or repairs and to reduce the risk of injury,
disengage PTO, set parking brake, stop engine and remove key to prevent unintended starting.

Craftsman Smart Lawn Connect Kit Specifications

General

Brand	Craftsman
Model	Smart Lawn Connect Kit
Category	Lawn Mower Accessories
Language	English

Summary

Remove Control Panel Retainer Plugs

Pry Retainer Ring from Recess

Insert screwdriver into recess and pry upward from retainer ring.

Pry Retainer Ring from Console

Insert screwdriver between metal console and retainer ring and pry upward.

Pull and Lift Control Panel

Unplug Wire Harness Connector

Connect Smart Lawn Connect Plug

Verify Plug Assembly Security

Tug on the plug assembly ends to ensure it is securely connected.

Reinstall Control Panel

Secure Control Panel with Retainers