To Next PageTo Next Page
Need help?Do you have a question about the Craftsman WEEDWACKER 358.796110 and is the answer not in the manual?
General| Engine Type | 2-Cycle |
|---|---|
| Engine Displacement | 25cc |
| Cutting Swath | 17 inches |
| Line Diameter | 0.095 inches |
| Shaft Type | Straight shaft |
Basic safety precautions for operating the trimmer, including dress and awareness.
Safety guidelines for unit maintenance and handling.
Precautions related to handling and using fuel for the trimmer.
Guidelines for safe cutting operations and avoiding hazards.
Procedures and precautions for moving and storing the trimmer.
Instructions for securely mounting the protective shield onto the trimmer.
Steps for connecting and adjusting the shoulder strap for proper use.
Guidance on positioning and tightening the secondary handle for control.
Familiarization with the trimmer's components and controls through illustrations.
Explanation of the ON/OFF switch, CHOKE, and PRIMER BULB operations.
Important steps and considerations before attempting to start the engine.
Details on the engine's oil requirement, type, and capacity.
Information on oil types, viscosity, and usage conditions with related cautions.
Step-by-step instructions for adding engine oil correctly.
Procedures for verifying the oil level before and during use.
Guidelines on gasoline type, octane, freshness, and gasohol usage.
Instructions on how to safely refuel the trimmer's tank.
Steps to safely shut down the engine.
General procedure for starting the engine.
Specific instructions for the initial startup of a new unit.
Detailed steps for starting the engine, including warm-up.
Procedure for restarting the engine after it has been used.
Correct posture and hand placement for safe and effective operation.
Techniques for trimming, scalping, mowing, and sweeping.
Overview of required maintenance tasks and their frequency.
General advice and warranty requirements for maintaining the unit.
Essential checks for fasteners, parts, engine oil, and unit condition before operation.
Detailed instructions for changing the engine oil.
Steps for draining and refilling the engine oil.
Procedures for verifying the oil level.
Instructions for cleaning or replacing the air filter.
Checking the muffler and spark arrestor for carbon buildup.
Steps for replacing the spark plug for optimal performance.
Step-by-step guide for replacing the trimmer line.
Information and caution regarding carburetor adjustments.
General safety and handling instructions for storing the unit.
Specific steps for preparing the trimmer for long-term storage.
Procedures for preparing the fuel system for storage.
Steps for engine oil and cylinder preparation for storage.
Final checks and recommendations for storing the unit.
Explains warranty rights, responsibilities, and coverage for emission control systems.
Details the specific emission control parts covered and terms of warranty.
Outlines procedures for filing claims and common exclusions from coverage.
Explains the expected hours of emission compliance for engines.
Describes the calculated number representing the relative level of emissions.
Illustrates a typical emissions compliance label found on the engine.
