Craig CCR9029 - Replace the Unit into the Water Proof Case as the Figures below; Mountings

4. Replace the unit into the water proof case as the figures below:
Fig. 1 Fig. 2 Fig. 3
Note: For the best result of water proof, always put the unit into the water case and make
sure it is completely closed and locked.
5. Mountings:
 Mounting the camera on the top of the helmet with the supplied assembly’s kit as the
figures below:
Select the Mount with the nut to mounted on the skateboard or surfboard
which equipped assemble screw. Then assemble/stuck the unit on it as follows figures.
Select the Mount without the nut to mounted on the helmet. Then
assemble/stuck the unit on it as follows figures.
Fig. 1 Fig. 2 Fig. 3 Fig. 4