Craig CS1203 - Main Unit Setup Procedures; Main Unit Battery Installation; Main Unit Channel Selection

Portable Sensor:
1.Bell Clip
2.Battery Compartment
3. C/ºF (Celsius/Fahrenheit) selection button
4.TX (Transmit) button
5.Channel selection button
o
BATTERY INSTALLATION AND CHANNEL SET UP
Main unit:
1.Press the tabs on the battery door and lift it off.
2.Install two (2) x AAA size batteries (NOT included) into the battery compartment as shown on the figure below
and the polarity markings inside battery compartment.
3.Replace the battery door.
4.Press the CHANNEL button repeatedly on the rear of cabinet to 1; 2 or 3 as desired. The selected channel
number will appear on the display Left-Bottom corner.
TIME ALARM
UP
DOWN
CHANNEL SNZ
1
2
3
4
5
C/ F TX
AAA 1.5V
AAA 1.5V
AAA 1.5VAAA
1.5V
AAA 1.5VAAA
1.5V
TIME ALARM
UP
DOWN
CHANNEL SNZ
TIME ALARM
UP
DOWN
CHANNEL SNZ
3