Craig CVD512a - System Setup: Audio and Configuration; Audio Setup and Night Mode Adjustment

2. If View Mode i s selected, press the Direction button ►to enter. Press the Direction buttons
▲, ▼ to selec
- 16-
SYSTEM SETUP
3. If TV system is selected, press the Direction button to enter. Press the Direction buttons , to select the
format of signals to PAL, NTSC or AUTO. Then press the Enter button to confirm the selection.
Press the SET UP button to save the setting and exit.
Set it to P if the color system of your TV is PAL.
AL
Set it to AUTO if the color system of your TV is multi.
Notes:
Set it to NTSC if the color system of your TV is NTSC. (Default setting. The TV signals in US, Canada and
Mexico is NTSC).
select video output modes to
Notes:
~ Set to Component if you connected the TV via the YUV jack on the player and YUV IN jacks on the TV as the
figure on page 9 .
~ Set to P-Scan if you connected the TV via the YUV jack on the player and YUV IN jacks on the TV (TV also
set to Progressive Video input mode) as the figure on page 9 .
Component or
P-Scan.
4. If Video output is selected, press the Direction button to enter. Press the Direction buttons , to
In Audio Setup Page:
If Ni ht Mode is selected, press the Direction button ►to enter. Press the Direction buttons ▲,▼
to select
" On/Off ", if On is selected, the maximum dynamic sound level will be reduced.
and photo.
Night Mode
z
g
t the view mode to match the picture si e and aspect ratio of the playin Video
g