Craig CVD512a - System Setup: Security and Preferences; Parental Control, Password, and Rating Levels; Default Settings, Screen Saver, and Last Memory

SYSTEM SETUP
In Rating Setup Page:
Press the Direction buttons , to select
Password
as desired.
Parental Control Set
then press the Direction b
utton to enter.
1 Control. If Parental is selected,
The Password Column will appear on
(Default password is 5050).
the screen. Enter the four digit password by
Rate levels:
1 :KID SAF, Kidsafe
2 :G , All ages
3 :PG, Parental Guidance
4 :PG-13, Parental Guidance less than 13 years old
5 :PGR, Under 17 years old, Parental Guidance suggested
6 :R, Under 17 years old, Parental Guidance strongly
7 :NC+17 years old and above
8 :ADULT, Adult only
2 If Set Password is selected , changed the password as follows:
A. Press the ENTER button to enter. The Enter Password column will appear on the screen.
B. Enter the 4 digit current password by press the numeric
C. Enter the 4 digit new password by press the numeric
D. Enter the new password again, Then press the ENTER button to confirm the settings.
E. Press the SETUP button to save the settings and exit.
then press the ENTER button twice,the New Password Column will appear on the screen.
then press the ENTER button, the Confirm Password Column will appear on the screen.
In Misc (Miscellaneous) Setup Page:
1. If Use Default Setting is selected, press the ENTER button to enter. Press the Direction or button to select
"Yes" or "No" then press the ENTER button to confirm the selection. If "Yes" is selected, all settings will reset to
Default Settings.
2. If Screen Saver is selected, press the Direction button to enter. Press the Direction or to select "On"
screen saver icon will appear on screen.
3. If Last Memory is selected, press the Direction button to enter. Press the Direction or button to select
"On" (turn on Last Memory function ) or "Off", then press the ENTER button to confirm selection.
- 17-
then press the Direction b
utton t o enter.
buttons
buttons
press the numeric buttons (0-9)
then press the ENTER button to confirm. Press the Direction button to enter. Press the Direction or button
to select the desired rate level as below then press the ENTER button to save the setting and exit.
or "Off" then press ENTER button to confirm the selection. if "On" is selected, when the unit is idle over
than 5 minutes,