Note:
If you touch the sensor
H /
°
F
, the control light will flash for a time of 5
seconds. If you do not press any button within 5 seconds or you press a button other
than SET, or , then the LED display will display the temperature in the room.
When the temperature in the room is lower than 15°F, the display will show "LO" (low
temperature). When the temperature in the room is higher than 99°F, the display will
show "HI" (high temperature). When the temperature is in the range 15 - 99°F, then the
display will show the actual temperature in the room.
Remote Control Operation
There are 6 buttons on the remote control. Their function is
equivalent to the functions of the touch sensors on the control
panel of the device. If you wish to use the remote control, point
the remote control at approximately the level of the control panel
with the display. The maximum signal range of the remote control
is 6 meters. If you place the remote in such a way that the
transmission of the signal is blocked by barrier, the signal may
not be transmitted at all.
CHANGING THE BATTERY
1. Remove the battery door on
the back of the remote.
2. Confirm battery polarity and
insert battery into the
battery door.
3. Insert battery door into
remote.
SAFETY PROTECTION SYSTEMS
This unit has protection safeguards that shut off the unit when components become
excessively hot or if it tips over.
TIP OVER SWITCH
This heater has a built-in safety feature to automatically turn off the device when it is
tipped over. If the device falls over this function serves as protection against a
dangerous situation.
OVERHEAT PROTECTION
The heater has an internal, over-heating safety device which automatically switches the
heater off if an over-heat situation is detected. If this should occur, unplug the
appliance and wait until the unit cools off. Once the unit has fully cooled, you can switch
it on again.
To Next Page
Loading...
