Crate BV-60H - Technical Specifications

Declaration Of Conformity
#35, Effective 01-01-2001
Manufacturer’s Name: SLM Electronics
Production Facility: 1901 Congressional Drive, St. Louis, MO 63146, USA
Production Facility: 700 Hwy 202 W, Yellville, AR 72687, USA
Shipping Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Office Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Product Type: Audio Amplifier
Complies with the following Standards:
Safety: EN60065, E60065, C22.2, UL6500 and/or UL813
EMC: Directive 89/336/EEC, EN55103, EN55013, EN61000,
and/or FCC 47CFR 15B clA
Supplementary information provided by:
SLM Electronics - R & D Engineering
1901 Congressional Drive, St Louis, MO 63146, USA
Tel.: 314-569-0141, Fax: 314-569-0175
BV-60H / BV-120H All Tube Guitar Amplifiers
Technical Specifications:
Output Power Rating
BV-60H 50 watts RMS @ 5% THD 8 or 16 ohm load, 120 VAC
BV-120H 100 watts RMS @ 5% THD 8 or 16 ohm load, 120 VAC
Gain Channel 1 66dB, tones at “10” @ 1kHz
Channel 2 101dB, tones @ “10” @ 1kHz
Tone Control Range
Channel 1
Low 16dB @ 100Hz
Mid 20dB @ 300Hz
High 10dB @ 10kHz
Channel 2
Low 15dB @ 100Hz
Mid 13dB @ 500Hz
High 10dB @ 10kHz
Presence 5dB @ 10kHz
Input Impedance 1M ohm
Maximum Signal Accepted 2.8V peak to peak
Tube Types
Preamp 12AX7A (3)
Power Amp BV-60H: 12AX7A (1), 6L6GT/5881 (2)
BV-120H: 12AX7A (1), 6L6GT/5881 (4)
Line Out Level 1.2V RMS nominal
Power Requirements
BV-60H 115V 60Hz, 110VA; 2.5A Slo-Blo Fuse
BV-120H 115V 60Hz, 180VA; 5A Slo-Blo Fuse
Size and Weight 12”H x 30.25”W x 10”D, 50lbs.
The BV-60H and 120H are covered with high-quality, durable Tolex
®
. To keep them looking their best, avoid
abrasive cleansers. Wipe the cabinets clean using a slightly dampened soft cloth. Do not spray cleaners directly
into the amplifier. Never use brass cleaners on the hardware since they could damage their protective coatings.
©2000 SLM ELECTRONICS • A division of St. Louis Music • 1400 Ferguson Avenue • St. Louis, Mo 63133
P/N 47-631-05 • 111103
www.crateamps.com
Crate continually develops new products, as well as improves existing ones. For this reason, the specifications and information in this manual are subject to change without notice.